| Fivepointfive |
01-16-2020 11:59 AM |
NCRS PARTS 1954 cORVETTE
COMPLETE CHASSIS--WITH REBUILT CORRECT ENGINE.
The Purists will roll over on this one: The project started as an NCRS project. Change of direction--going for a Restomod using LS and C-4 components. What I have left is a nice frame--complete with correct steering brakes, rear end, and rebuilt and correct number engine--(never run since rebuilt). I am using the body and trim, so that is not available, but seats, (with no upholstery), but good springs and fresh paint. All gauges--but no radio, and all the stock components--starter, generator, pedals, regulator, radiator, heater, etc. Complete and correct steering wheel, and a bunch of misc stock parts and a few new parts. I have two powerglides that go with the deal, but they will need to be rebuilt. And the rare gear shift setup is included. The exhaust manifold is included and an intake manifold is included, BUT the stock intake and the 3 side drafts are not available. I am working on the current chassis, and I need the original chassis for measurements, so all this stuff is not available just yet, but a small deposit will hold it. I am asking $17,000. Of course if you broke it down by individual items--rebuilt engine, steering wheel, seats, gauges, frame, etc. it would sell for much more, but I am 77, and realistically don't have the time to sell the parts individually! I am 20 minutes from DFW and would pick you up if you want to take a look, and I prefer you look before you buy so there are no unknowns. bunkyg5@verizon.net.
|
