C3 1980 Clip speedometer gear broken
It seems that the speedometer drive gear is moving on the shaft and therefore the speedocable does not turn.
I checked under the car what has to be done and would be happy when somebody who did this already could give me some advise/feedback. I think I will have to take the front part of the exhaust down as well as the gearboxsupport and the driveshaft. Then I could slip the endpart of the gearbox after loosening 4 screws rearwards and should the have access to the shaft with the speedometer drive gear and the clip. Have I forgotn something? Any advise where I have to be especially careful to avoid mistakes? Any thoughts would be much appreciated. |
What year? Your profile is blank. Is it Manual or Auto?
Originally Posted by swissvet
(Post 1607760814)
It seems that the speedometer drive gear is moving on the shaft and therefore the speedocable does not turn.
I checked under the car what has to be done and would be happy when somebody who did this already could give me some advise/feedback. I think I will have to take the front part of the exhaust down as well as the gearboxsupport and the driveshaft. Then I could slip the endpart of the gearbox after loosening 4 screws rearwards and should the have access to the shaft with the speedometer drive gear and the clip. Have I forgotn something? Any advise where I have to be especially careful to avoid mistakes? Any thoughts would be much appreciated. |
Originally Posted by carriljc
(Post 1607761066)
What year? Your profile is blank. Is it Manual or Auto?
|
Well, if I was you I'd hold up the tranny and slide the exhaust and crossmember out of the way to have a lot of room to work.
Originally Posted by swissvet
(Post 1607761864)
1980, auto
|
All times are GMT -4. The time now is 07:08 AM. |
© 2024 MH Sub I, LLC dba Internet Brands