I have something special to sell for you. Are you interested and what should I ask for it?
 

Hi guys and gals

I just managed to fit the B&M quicksilver shifter into my vette. Therefore I had to make a special plate out of stainless steel.
After measureing, drawing and manufacturing the plate I noticed that we chose the wrong surface design :eek:
The rest of my cars interior has a different design so I can not use it and we´ll have to make another plate. That sucks..
Well, at least I thought that I can post a picture of the plate and offer it for sale.
http://temp.corvetteforum.net/c3/markus_p//p7240001.jpg
The plate features two big round cutouts (diameter=53mm) for additional gauges and two small round cutouts (d=28mm) for a starter switch and a 12/24 V connection.
Further more there was made an engraving into the plate (check the pic) directly under the small cutouts. "Start" and "12V/24V"
This plate was a lot of work and if somebody tries to fit a quicksilver shifter into his car this is something he could use. There are no tunnel modifications needed to mount the shifter, the only backdraw is that you´ll have to find another place for the heater controls.
To mount the plate you have to cutout the original plate and use it´s frame.
I´m now on vacation for three weeks (email is senseless, because this is my company adress) but I´ll check out the forum every now and then.
As always
Markus