CorvetteForum - Chevrolet Corvette Forum Discussion - Search Results

Notices
Search: Posts Made By: terry82
Showing results 1 to 15 of 15
Search took 0.36 seconds.
04-28-2018, 10:26 AM
Replies: 13
Views: 517
Posted By crazydad42

I just my trans to the shop and told them to...

I just my trans to the shop and told them to build it for 500 torque. I know they put in a beast sunshell but I'm not sure what else they did. If I were to do it again. I'd just buy a whole trans...
09-10-2017, 05:17 PM
Replies: 18
Views: 1,157
Posted By Dynra Rockets

OEM 81-82 have the tubes up high OEM 84-91 have...

OEM 81-82 have the tubes up high
OEM 84-91 have the tubes down low.

If you have an automatic you can use either. If you have a stock manual with Z bar then you cannot use the C4 on the drivers...
08-15-2017, 06:06 PM
Replies: 15
Views: 734
Posted By REELAV8R

small metal box attatched to the firewall just...

small metal box attatched to the firewall just above and to the right (as you are facing rear of car) of your blower motor. Should have a couple of plugs into it. Look to see if they are melted or...
08-15-2017, 04:21 PM
Replies: 15
Views: 734
Posted By REELAV8R

I'd look at the fan connections, The fan relay...

I'd look at the fan connections, The fan relay contactor ( for wear and corrosion) and the size of ground wire you used with the fan. Any one of these can cause a high amperage draw. Should have a...
Forum: C3 General
07-14-2017, 04:45 PM
Replies: 39
Views: 2,170
Posted By Dynra Rockets

They are 407 stainless. (ie, low nickle and...

They are 407 stainless. (ie, low nickle and chromium content, mostly mild steel). That means you can weld on it with standard rod you would use for mild steel without issue.

I did mine myself...
07-10-2017, 09:20 AM
Replies: 65
Views: 3,135
Posted By Street Rat

That's when you send the little people in. Wives...

That's when you send the little people in. Wives and kids come to mind.
:D
Forum: C3 General
07-05-2017, 07:37 PM
Replies: 5
Views: 196
Posted By Big2Bird

90% sure it's 15/16" socket. Not metric.

90% sure it's 15/16" socket. Not metric.
Forum: C3 General
06-29-2017, 08:49 AM
Replies: 6
Views: 271

dryer

first remove the rocker panel from the passenger side then 3 screws from the bottom for access panel and it is super easy:rock:
05-20-2017, 03:05 PM
Replies: 2
Views: 301
Posted By Buccaneer

Some 82 CFI info from GM engineer

Just a couple pages from this book which is a good read for the CFI guys. Short, but somewhat informative from the engineering perspective. Got this from a friend at vettes and caddies this morning....
Forum: C3 General
05-19-2017, 10:12 AM
Replies: 39
Views: 2,170
Posted By garrettb

They didn't say, but I'm 99% certain they're...

They didn't say, but I'm 99% certain they're stainless.
Forum: C3 General
11-05-2016, 10:41 PM
Replies: 3,314
Views: 230,067
Posted By Bergerboy

Experienced the dreaded "Bleeder Valve Snap-Off"...

Experienced the dreaded "Bleeder Valve Snap-Off" on my right front caliper.
Snapped off during a re-build, and left only less than 1/8" of threaded shaft exposed.
Any advice on how to extract the...
08-20-2016, 05:26 PM
Replies: 20
Views: 2,623
Posted By Jebbysan

It was a 305ci. rated 165 stock.....RPO LO3 The...

It was a 305ci. rated 165 stock.....RPO LO3
The LG4 was a 4bbl....rated at 145......
The Camaro crossfire system was identical though.

You would need about 200 hp to run 15.5 in a 3rd gen Z-28....
Forum: C3 General
06-11-2016, 08:13 PM
Replies: 11
Views: 1,264
Posted By Paul L

I hope you can see my original post and pics....

I hope you can see my original post and pics. Believe me it has made a world of driving pleasure since I did that job several moons ago.
Forum: C3 General
03-11-2016, 10:49 AM
Replies: 15
Views: 698
Posted By MelWff

Vacuum

The hose collapses due to atmospheric pressure being greater than internal pressure. This will only occur during the cool down process when the system attempts to suck coolant back into the...
Showing results 1 to 15 of 15


 
Forum Jump

Sponsored Ads
Vendor Directory

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.