CorvetteForum - Chevrolet Corvette Forum Discussion - Search Results

Notices
Search: Posts Made By: RX-Ben
Showing results 1 to 7 of 7
Search took 0.02 seconds.
05-29-2017, 06:03 PM
Replies: 47
Views: 3,985
Posted By RX-Ben

one wire. The logger will use it's ground (which...

one wire. The logger will use it's ground (which should go to a frame rail). Not ideal (theoretically), but plenty good for temp sensors.
05-29-2017, 03:38 PM
Replies: 47
Views: 3,985
Posted By RX-Ben

Right, if you are using the OEM temp sensor(s) -...

Right, if you are using the OEM temp sensor(s) - the PCM provides a pull-up resistor so you can just tap into the wire - you do not want to introduce a 2nd pull-up.
08-29-2016, 12:45 PM
Replies: 0
Views: 2,679
Posted By RX-Ben

Walbro 450 install w/hydramat

There are some other posts on this, here is yet another take.
I am using a separate fuel filter and fuel pressure regulator, so this is obviously a bit different.
The Hydramat you want to use is...
06-21-2016, 01:13 PM
Replies: 47
Views: 3,985
Posted By RX-Ben

Cliff notes: C5 data bus sucks. Tapping into...

Cliff notes:
C5 data bus sucks.
Tapping into the OEM sensors has no effect.

----------------------------------------

Here is some rudimentary info on logging on a C5 and, I think, an '05 C6...
03-18-2016, 11:31 AM
Replies: 20
Views: 6,967
Posted By RX-Ben

I asked this question a couple months ago (after...

I asked this question a couple months ago (after taking a look at my MSD intake) and the responses I got were "they should fit" but obviously nobody had spent any time with the hardware. The bulges...
02-05-2016, 12:44 PM
Replies: 8
Views: 796
Posted By RX-Ben

Not quite, but close, see diagram in this thread:...

Not quite, but close, see diagram in this thread:
https://www.corvetteforum.com/forums/c6-corvette-general-discussion/2078041-ever-have-to-change-the-fuel-filter-in-the-c6.html

If the car was run...
02-05-2016, 11:31 AM
Replies: 8
Views: 796
Posted By RX-Ben

Right, fueling calcs in the PCM are based on...

Right, fueling calcs in the PCM are based on 58psi, so it is critical to actually have 58psi at the rails as the PCM is blind to the actual fuel pressure.
Hopefully just needs a new fuel filter.
Showing results 1 to 7 of 7


 
Forum Jump

Sponsored Ads
Vendor Directory

Contact Us About Us Archive Advertising Cookie Policy Privacy Statement Terms of Service

© 2018 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.