CorvetteForum - Chevrolet Corvette Forum Discussion - Search Results


Showing results 1 to 7 of 7
Search took 0.02 seconds.
Search: Posts Made By: RX-Ben
Forum: Autocrossing & Roadracing 05-29-2017, 06:03 PM
Replies: 40
Views: 2,497
Posted By RX-Ben
one wire. The logger will use it's ground (which...

one wire. The logger will use it's ground (which should go to a frame rail). Not ideal (theoretically), but plenty good for temp sensors.
Forum: Autocrossing & Roadracing 05-29-2017, 03:38 PM
Replies: 40
Views: 2,497
Posted By RX-Ben
Right, if you are using the OEM temp sensor(s) -...

Right, if you are using the OEM temp sensor(s) - the PCM provides a pull-up resistor so you can just tap into the wire - you do not want to introduce a 2nd pull-up.
Forum: C6 Corvette ZR1 & Z06 08-29-2016, 12:45 PM
Replies: 0
Views: 1,715
Posted By RX-Ben
Walbro 450 install w/hydramat

There are some other posts on this, here is yet another take.
I am using a separate fuel filter and fuel pressure regulator, so this is obviously a bit different.
The Hydramat you want to use is...
Forum: Autocrossing & Roadracing 06-21-2016, 01:13 PM
Replies: 40
Views: 2,497
Posted By RX-Ben
Cliff notes: C5 data bus sucks. Tapping into...

Cliff notes:
C5 data bus sucks.
Tapping into the OEM sensors has no effect.

----------------------------------------

Here is some rudimentary info on logging on a C5 and, I think, an '05 C6...
Forum: C6 Corvette ZR1 & Z06 03-18-2016, 11:31 AM
Replies: 20
Views: 5,634
Posted By RX-Ben
I asked this question a couple months ago (after...

I asked this question a couple months ago (after taking a look at my MSD intake) and the responses I got were "they should fit" but obviously nobody had spent any time with the hardware. The bulges...
Forum: C6 Corvette ZR1 & Z06 02-05-2016, 12:44 PM
Replies: 8
Views: 662
Posted By RX-Ben
Not quite, but close, see diagram in this thread:...

Not quite, but close, see diagram in this thread:
https://www.corvetteforum.com/forums/c6-corvette-general-discussion/2078041-ever-have-to-change-the-fuel-filter-in-the-c6.html

If the car was run...
Forum: C6 Corvette ZR1 & Z06 02-05-2016, 11:31 AM
Replies: 8
Views: 662
Posted By RX-Ben
Right, fueling calcs in the PCM are based on...

Right, fueling calcs in the PCM are based on 58psi, so it is critical to actually have 58psi at the rails as the PCM is blind to the actual fuel pressure.
Hopefully just needs a new fuel filter.
Showing results 1 to 7 of 7

 
Forum Jump
Sponsored Ads
Vendor Directory

All times are GMT -4. The time now is 11:29 AM.


We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.