CorvetteForum - Chevrolet Corvette Forum Discussion - Search Results

 
Search: Posts Made By: MikeOC
Showing results 1 to 25 of 71
Search took 0.50 seconds.
01-19-2019, 02:33 PM
Replies: 90
Views: 9,544
Posted By [email protected]

They're separate pieces but intertwined. Theres...

They're separate pieces but intertwined. Theres wiggle room but they're not coming apart.


We're thinking closer to 35-40 at the wheels
01-09-2019, 12:03 PM
Replies: 39
Views: 2,091
Posted By nuke61

I can't answer the legal question, but the actual...

I can't answer the legal question, but the actual Bill reads:
Existing law requires every motor vehicle subject to registration to be equipped with an adequate muffler in constant operation and...
11-27-2018, 10:46 PM
Replies: 391
Views: 70,737
Posted By c5racr1

Racing brake .com, they were a one off set

Racing brake .com, they were a one off set
11-03-2018, 03:12 PM
Replies: 32
Views: 1,873
Posted By GSpeed

Hi Mike, you can budget roughly 5500-6500...

Hi Mike, you can budget roughly 5500-6500 depending on sensors, and what you chose to add. We are very close to being forsale. We have some beta work in development currently and a few shops waiting...
10-25-2018, 05:35 PM
Replies: 4
Views: 332
Posted By Treadhead

Victory red, matches the GM touch up paint I have.

Victory red, matches the GM touch up paint I have.
10-18-2018, 04:21 PM
Replies: 34
Views: 1,476
Posted By lamboworld

HPR built my motor using TI rods and APR bolts...

HPR built my motor using TI rods and APR bolts and I don't think they did anything to the rods other than hone the small end to fit a .927 pin.
10-13-2018, 02:52 PM
Replies: 32
Views: 1,873
Posted By GSpeed

Yes, I believe 16 lambdas is the max it will...

Yes, I believe 16 lambdas is the max it will support.



Yes, with enough programming!



On paper it will work. We have an 07 car to validate on in the shop now.
08-28-2018, 08:06 PM
Replies: 36
Views: 1,495
Posted By Magna_Flow

We'd agree with most people in this thread-keep...

We'd agree with most people in this thread-keep them on. It doesn't seem worth dealing with all the downsides for just a few HP. Modern cats do just fine in a properly tuned FI setup. Catalyst...
08-26-2018, 01:50 PM
Replies: 36
Views: 1,495
Posted By Dan_the_C5_Man

Cats ON please. I am no tree hugger, but I also...

Cats ON please. I am no tree hugger, but I also don't want to breathe polluted air from unscrubbed exhaust, all in the name of 5 HP. Thanks. :cheers:
08-08-2018, 12:59 PM
Replies: 59
Views: 5,380
Posted By TheRadioFlyer

Thank you for bringing this to my attention. I...

Thank you for bringing this to my attention. I have verified that this is indeed an issue. I should be able to fix this with a minor addition to the harness.
08-06-2018, 06:30 AM
Replies: 17
Views: 537
Posted By Undy

Barnette Designs are the ones that did mine. The...

Barnette Designs are the ones that did mine. The emblem is 100% CNC'd aluminum. https://www.corvetteforum.com/forums/c6-corvette-general-discussion/2723021-new-badges-from-austin-barnett.html...
07-27-2018, 05:05 PM
Replies: 739
Views: 73,269
Posted By [email protected]

you are in the ocean shipment, probably mid...

you are in the ocean shipment, probably mid August is conservative
07-25-2018, 10:28 PM
Replies: 21
Views: 1,073
Posted By Mordeth

I own a C6z race car, a C7Z and I have driven a...

I own a C6z race car, a C7Z and I have driven a C6ZR1 on a race track and instructed students in them. I am unbiased and I love all Corvettes. My cars are driven 10/10ths at race speed. As for your...
07-19-2018, 10:09 AM
Replies: 739
Views: 73,269
Posted By doomi

There is no delay caused by the harness. ...

There is no delay caused by the harness.



I'm my case, yes the amber turn signals stay lit as DRL's. It's hard for me to take pics of the DRL's because the DRL's turn off when you put up the...
07-18-2018, 10:26 AM
Replies: 8
Views: 854
Posted By 03Zcrit

There’s a lot of structural work needed to make...

There’s a lot of structural work needed to make it safe. Here is a guy that successfully completed the conversion:

Targa conversion...
07-11-2018, 06:27 PM
Replies: 348
Views: 24,994
Posted By Unreal

Those are all good questions. I know after...

Those are all good questions. I know after running a few tanks of non torco through, plugs would look fine again. My pistons/chambers/etc showed no orange after a few thousand miles of e50-e85. So I...
07-11-2018, 06:19 PM
Replies: 348
Views: 24,994
Posted By Mordeth

I use Boostane Professional. I have tried both...

I use Boostane Professional. I have tried both Torco and Boostane but I like Boostane better as you need less of it to get to the same desired octane level and it also does not separate and settle at...
07-11-2018, 03:28 PM
Replies: 348
Views: 24,994
Posted By jayyyw

Doesn't clean them that well.

Doesn't clean them that well.
05-21-2018, 10:02 AM
Replies: 11
Views: 562
Posted By racerns

Please Vote for Rear CC Rotor Question in Ask Tadge

Those of us with ZR1s and Z07s have run into the issue of the rear carbon ceramic rotors being shown as unavailable or discontinued throughout the country. I have posted a question in the Ask Tadge...
05-21-2018, 09:46 AM
Replies: 57
Views: 5,376
Posted By racerns

I posted the question about the rear CC rotors...

I posted the question about the rear CC rotors being discontinued in the Ask Tadge section. Please vote for it if you would like to see it answered.
Vote...
04-06-2018, 09:05 PM
Replies: 40
Views: 8,273
Posted By TPSMak

Price is $629.99 and we rebuild them to make sure...

Price is $629.99 and we rebuild them to make sure they work properly.. If we don't rebuild them we won't guarantee they won't leak. The rebuild is just boots and seals. Yes we can leave the logo...
04-03-2018, 06:39 PM
Replies: 231
Views: 21,323
Posted By Mordeth

35 track days. 2-3 hours of hard core road...

35 track days. 2-3 hours of hard core road course work and timed racing per day. This isn't autocross in a parking lot or blasts down a runway. It is 10/10ths driving on prepared racing surface...
03-10-2018, 10:21 AM
Replies: 11
Views: 683
Posted By STANG KILLA SS

yes its 100% fine to run a square setup. even...

yes its 100% fine to run a square setup. even racing. you will have 0 issues. and yeah thats why i did it for tire rotation.
with that being said, my camaro loved the square setup. (nose heavy)
i...
03-08-2018, 08:44 AM
Replies: 32
Views: 2,514
Posted By Mordeth

STD still corrects for weather, but corrects to a...

STD still corrects for weather, but corrects to a different standard. (Lower temp and higher pressure). So STD corrects to 60 degrees and SAE to 77 degrees. Usually assume that STD will read 4-5%...
02-21-2018, 07:11 AM
Replies: 66
Views: 4,714
Posted By GARY2004Z06

ITBs are very responsive at the low end due to...

ITBs are very responsive at the low end due to the smaller TBs and the TQ curve can be adjusted via trumpet length. Longer trumpets will move your curve downward to the lower rpm range. Rob's 388...
Showing results 1 to 25 of 71
 


 
Forum Jump

Sponsored Ads
Vendor Directory

Contact Us - About Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.