CorvetteForum - Chevrolet Corvette Forum Discussion - Search Results

Notices
 
Search: Posts Made By: JWASR64
Showing results 1 to 25 of 29
Search took 0.35 seconds.
10-10-2018, 01:11 PM
Replies: 1
Views: 176
Posted By ChumpVette

Wilcox, just make sure you buy when it is on...

Wilcox, just make sure you buy when it is on sale.
...
08-29-2018, 09:24 PM
Replies: 7
Views: 362
Posted By drcook

Make the seams in the middle. There will be throw...

Make the seams in the middle. There will be throw away from the edges, but it will turn out much nicer. Plus they were only 10 bucks or so. I believe she did some gluing on the edges, besides duct...
08-29-2018, 02:38 PM
Replies: 7
Views: 362
Posted By drcook

we have only had the car out once since we bought...

we have only had the car out once since we bought it. my wife said she thought it was quieter. we made a pad out of the 1/2 in thick anti-fatigue mats:

these
...
07-16-2018, 02:30 PM
Replies: 11
Views: 329
Posted By Tached

It's a simple affair, press tensioner, you should...

It's a simple affair, press tensioner, you should see/feel slack in the belt, slide it off to the side, release tensioner, continue to remove belt. Route new belt, press tensioner back and place...
07-15-2018, 12:24 PM
Replies: 11
Views: 329
Posted By JBPC4

You can release it in between.

You can release it in between.
03-30-2018, 11:19 AM
Replies: 3
Views: 181
Posted By Tom400CFI

There are several places. Two I can think of...

There are several places. Two I can think of right off are:
*the large post on the starter motor
*The positive junction block behind the battery.
02-16-2018, 03:40 PM
Replies: 4
Views: 264
Posted By Kevova

It's about the same as the rear. As long as you...

It's about the same as the rear. As long as you disconnect both ends, bar should not be loaded.
02-10-2018, 01:04 PM
Replies: 28
Views: 1,356
Posted By whitemj1948

Quiet and they seem to hang on pretty good, won't...

Quiet and they seem to hang on pretty good, won't tell you how I know, the ride is pretty good, not limo quality but very good.
02-10-2018, 09:50 AM
Replies: 3
Views: 364
Posted By 1stVetteFinally

I had a pair for a short time on the back of my...

I had a pair for a short time on the back of my '92 Vette. While I had them, I was very happy with them as street tires. Gripped good and performed very well in the rain. I only had them a short time...
01-03-2018, 05:46 PM
Replies: 4
Views: 410
Posted By pcolt94

My apologies, I read it too fast and thought you...

My apologies, I read it too fast and thought you wanted location.

I'll read better next time. :)

Thanx - ZR-1 :D
01-03-2018, 05:34 PM
Replies: 4
Views: 410
Posted By WVZR-1

Location is correct - 15A FUSE

Location is correct - 15A FUSE
12-18-2017, 02:25 PM
Replies: 17
Views: 596
Posted By biggiefl

If you go to tire rack and type in tire size it...

If you go to tire rack and type in tire size it will show all tires in that size like a spreadsheet. This will show height, width, weight, etc.
07-07-2017, 03:42 PM
Replies: 3
Views: 355
Posted By drcook

When ever I put thread locker on, I only use Blue...

When ever I put thread locker on, I only use Blue Loctite (or equivalent). It will break loose with hand tools. Red Loctite takes HEAT and hand tools to disassemble.
11-12-2016, 10:31 AM
Replies: 13
Views: 1,366
Posted By WVZR-1

I don't believe you can rely upon information...

I don't believe you can rely upon information that's "eight" and "four" years old. There's many horns that work, I pointed the OP a direction to use as a "shopping information tool". I suggested no...
11-12-2016, 07:59 AM
Replies: 13
Views: 1,366
Posted By WVZR-1

Right side is either A or C if you suspect...

Right side is either A or C if you suspect everything being OE on the LEFT.

A FIAMM horn 72205 I believe came with the correct connection but of course an incorrect bracket. They don't show that...
11-02-2016, 02:58 PM
Replies: 9
Views: 608
Posted By desertmike1

Your fine, it's not uncommon during an "In rush"...

Your fine, it's not uncommon during an "In rush" to have a dip in voltage. Optimum Voltage should be 13.8-14.2 on a fully charged battery.. on a low charged Battery you will see voltage as high as 16...
11-02-2016, 01:18 PM
Replies: 9
Views: 608
Posted By antfarmer2

No might just need your connections cleaned.

No might just need your connections cleaned.
09-23-2016, 07:23 PM
Replies: 3
Views: 465
Posted By antfarmer2

I did mine both from the bottom pass side was a...

I did mine both from the bottom pass side was a bit harder. Go to orielys and get their o2 socket set for free use the short one. $20 deposit or $25 to buy.
09-23-2016, 05:27 PM
Replies: 3
Views: 465
Posted By sluggballz

I just changed mine on my 95 two weeks ago. The...

I just changed mine on my 95 two weeks ago. The drivers side is best done from under the car the passenger side was done from outside the engine bay standing up until it was time to finish the last...
09-20-2016, 02:26 PM
Replies: 7
Views: 738
Posted By Joe C

+2 -- bosch! probably the last half dozen, or...

+2 -- bosch! probably the last half dozen, or so, I've purchased have been bosch. no issues ever. :rock:
09-20-2016, 02:17 PM
Replies: 7
Views: 738
Posted By ddahlgren

+! Bosch

+! Bosch
09-20-2016, 02:10 PM
Replies: 7
Views: 738
Posted By RICHARD TILL

A Bosch worked well for me in my ZR-1.

A Bosch worked well for me in my ZR-1.
08-12-2016, 11:23 AM
Replies: 5
Views: 970
Posted By hcbph

I've looked at both of them, comparing some of...

I've looked at both of them, comparing some of the replacements for the same locations. If you don't mark them, I defy you to tell who made which.
07-29-2016, 03:06 PM
Replies: 6
Views: 417
Posted By HAD2HAV2

I did this repair on my 88 back in 2001. First...

I did this repair on my 88 back in 2001. First time I had ever attempted a repair like this other than doing regular engine or suspension work. At that time I had no YouTube or camera phone for help...
07-29-2016, 02:36 PM
Replies: 6
Views: 417
Posted By Izzy Dizzy

Headlight pucks

Just finished doing my 89. Tip: 2" masking tape around the perimeter of the headlight door as a precaution against scratching during removal and reinstallation of the assembly.
Driver side vs...
Showing results 1 to 25 of 29
 


 
Forum Jump

Sponsored Ads
Vendor Directory

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service

© 2018 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.