CorvetteForum - Chevrolet Corvette Forum Discussion - Search Results

Notices
Search: Posts Made By: Silver Bullet C6
Showing results 1 to 12 of 12
Search took 0.03 seconds.
06-23-2018, 03:56 PM
Replies: 23
Views: 641
Posted By Silver Bullet C6

I have Spec twin disc clutch. It was installed...

I have Spec twin disc clutch. It was installed by AMP in Grand Prairie. It's rated for 900 tq/ 900 hp.
It works well, the release point is higher than stock but works well for my H/C/I Z06.
06-21-2018, 11:24 AM
Replies: 20
Views: 958
Posted By Silver Bullet C6

9000 RPM engine..:smiliedrool::smiliedrool:

9000 RPM engine..:smiliedrool::smiliedrool:
04-28-2018, 12:11 PM
Replies: 4
Views: 769
Posted By Silver Bullet C6

Very impressive set of cars/ work. I hope y'all...

Very impressive set of cars/ work. I hope y'all enjoyed Texas.
03-05-2018, 09:11 PM
Replies: 79
Views: 3,527
Posted By Silver Bullet C6

Congrats on the new Z06! My advice is that if...

Congrats on the new Z06!
My advice is that if you are going to do an intake, go with a ported MSD.
I found a ported FAST 102 on sale, but all my research has the MSD giving the best TQ and HP...
02-08-2018, 03:00 PM
Replies: 44
Views: 2,443
Posted By Silver Bullet C6

I have a 940 whp , Powerglide C6 Corvette and can...

I have a 940 whp , Powerglide C6 Corvette and can tell you I still enjoy driving my H/C/I Z06 a lot. I've done a lil weight reduction with it and just the feel of high NA HP and light weight is a...
04-19-2017, 08:03 PM
Replies: 380
Views: 75,387
Posted By Silver Bullet C6

Jake, Does Forgestar make a 17 x 11 rear wheel...

Jake,
Does Forgestar make a 17 x 11 rear wheel with Z06 off sets?
01-30-2017, 11:46 PM
Replies: 16
Views: 1,157
Posted By Silver Bullet C6

With the A6 trans you have (I assume stock...

With the A6 trans you have (I assume stock converter) you will not be able to go too big on the cam without getting some surge at idle. If you had a higher stall converter, you could go with a...
01-22-2016, 09:40 AM
Replies: 5
Views: 1,466
Posted By Silver Bullet C6

8 psi is too much for an LS7 to run in stock form...

8 psi is too much for an LS7 to run in stock form and without meth injection or a race gas tune. The LS7 is not built to handle boost well and at 8 psi with 11:1 comp ratio, detonation is easy. ...
12-17-2015, 11:24 AM
Replies: 100
Views: 7,916
Posted By Silver Bullet C6

I ran an Si trim A&A kit on an A6 tranny with...

I ran an Si trim A&A kit on an A6 tranny with meth at 14-15 psi and the engine was fine (Josh tuned it when he was still in Texas). I sold the LS3 and it ran fine for the new owner. At 9 psi on a...
10-24-2015, 09:18 PM
Replies: 17
Views: 1,789
Posted By Silver Bullet C6

:rock: Very Nice! Your car runs hard. :rock:

:rock: Very Nice! Your car runs hard. :rock:
07-01-2012, 11:24 AM
Replies: 47
Views: 7,670
Posted By Silver Bullet C6

I am running the OEM rad with a Spal dual fan. ...

I am running the OEM rad with a Spal dual fan.
I recently added more power with a built engine/ bigger blower and also had cooling upgrades done. In combination with a dual fan set up, you might...
04-07-2011, 09:25 AM
Replies: 12
Views: 9,911
Posted By Silver Bullet C6

If you're not concerned at all with drag race...

If you're not concerned at all with drag race times, I'd suggest a 2800... lock up is considered best.
Showing results 1 to 12 of 12


 
Forum Jump

Sponsored Ads
Vendor Directory

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.