CorvetteForum - Chevrolet Corvette Forum Discussion - Search Results

Notices
 
Search: Posts Made By: Sunnyvale Dave
Showing results 1 to 25 of 80
Search took 0.45 seconds.
10-09-2018, 11:20 PM
Replies: 1
Views: 369
Posted By Handi

Just For Corvettes raised ($1,843.00) dollars...

Just For Corvettes raised ($1,843.00) dollars for the Veterans Affairs Northern California Health Care System (VANCHCS). Many Thanks to all of the members who helped put on this event to help our...
10-05-2018, 05:34 PM
Replies: 8
Views: 547
Posted By Parcival

Car is back from repairs. Took about 9 days to...

Car is back from repairs. Took about 9 days to fix the damage I posted but i'm satisfied with the work, especially on the color match. Oddly, I noticed they even re-did my hood stinger wrap without...
09-19-2018, 10:07 PM
Replies: 33
Views: 2,789
Posted By ptroxx

i must agree. I thought it was very busy. I had...

i must agree. I thought it was very busy. I had a TON of people around my car all day long it seemed.


Heres a little slid I did with a fe crowd shots.

Enjoy
...
09-19-2018, 04:41 PM
Replies: 33
Views: 2,789
Posted By c7fasteddie

Actually, there were more people this time than...

Actually, there were more people this time than ever before! They where at the max of 165 Corvettes. CONGRATULATIONS SCCA_ YOU PUT ON THE BEST SHOW OF ALL!!!!
09-11-2018, 04:14 PM
Replies: 10
Views: 580
Posted By jlbsam

i did take the squeeze pad actuator off the door...

i did take the squeeze pad actuator off the door and cleaned it. so far, no problems!
08-29-2018, 10:46 PM
Replies: 33
Views: 2,789
Posted By Handi

We will be there !!

We will be there !!
08-29-2018, 10:32 AM
Replies: 21
Views: 950
Posted By Bbot89

not the clutch, but the clutch fluid and...

not the clutch, but the clutch fluid and transmission fluid.
08-11-2018, 08:53 AM
Replies: 9
Views: 478
Posted By starvnmarvin1

C6 Top Issue/repair

Yesterday I broke down and took the C6 to a local top shop since I wasn't up to working on straps if that were the case. They diagnosed the issue that the rear of the trunk lid wasn't sitting...
08-05-2018, 11:44 AM
Replies: 6
Views: 368
Posted By farmington

This is standard maintenance. Should be done...

This is standard maintenance. Should be done yearly or as needed.
07-06-2018, 09:50 PM
Replies: 27
Views: 1,214
Posted By whitephang

replace your cabin air filters!

been lurking the forums here. i bought a genuine one from Adelco on my base 2008. my old one was like black and deformed in a way. new one is so fresh. cheap and easy. its for sure worth it to change...
06-20-2018, 08:54 PM
Replies: 29
Views: 2,428
Posted By AORoads

Don't feel badly. Not everyone has the skill, the...

Don't feel badly. Not everyone has the skill, the physical ability or the time to do some of these things. That goes for z06clif, too. I'd much rather see the helpful suggestions as to where products...
06-17-2018, 04:09 PM
Replies: 10
Views: 857
Posted By ptroxx

SO does that mean you like the pics or not ? ? ?...

SO does that mean you like the pics or not ? ? ? :hide::hide:
06-11-2018, 08:01 PM
Replies: 33
Views: 2,026
Posted By RichieRichZ06

If you're using the online appt scheduler on the...

If you're using the online appt scheduler on the website, it defaults to that long. GM doesn't have a way to check the schedule before allowing a customer to book an appt and they were severely over...
06-10-2018, 12:47 PM
Replies: 33
Views: 2,026
Posted By DWillys

Sadly, not a figure of speech. It was an actual...

Sadly, not a figure of speech. It was an actual rubber band. I guess they figured no one would know...
04-21-2018, 02:07 PM
Replies: 5
Views: 311
Posted By Yokesc5

Use a firm piece of 1 inch foam over the original...

Use a firm piece of 1 inch foam over the original n stretch it tite, you can use tie wraps to get started , hog nose later. Pulling the ends to fit first, workg the center pulling out the creases as...
04-21-2018, 11:22 AM
Replies: 5
Views: 311
Posted By BADBIRDCAGE

Upholstery shop installed new foam bottom...

Upholstery shop installed new foam bottom (Genuine GM part) on my driver side seat along with using a piece of burlap over the spring supports on both driver and passenger seat bottoms. Reused...
04-21-2018, 10:45 AM
Replies: 5
Views: 311
Posted By windyC6

Not sure what the service manager meant when he...

Not sure what the service manager meant when he said that it may not fit due to being stretched out (i'm assuming). Seems to me that the new pre made-to-fit foam would at least make the old cover...
04-21-2018, 10:24 AM
Replies: 5
Views: 311
Posted By 07MontyRed

I have rebuilt my drivers seat twice in the last...

I have rebuilt my drivers seat twice in the last 12 years. The first time I used the original seat cover with new foam and repair kit ... the cover fit fine (it still looked sort of old and worn, but...
04-15-2018, 11:30 AM
Replies: 13
Views: 3,494
Posted By JerryU

As I recall the grooves in the Scrape Armor are...

As I recall the grooves in the Scrape Armor are to reduce the force on the part and splitter as it drags on whatever it hits.

My pic that shows the bolt sticking up was from a wrong install! ...
04-14-2018, 06:43 PM
Replies: 13
Views: 3,494
Posted By robertbruce

They are more expensive by $100.00. I like them...

They are more expensive by $100.00. I like them because they are two pieces instead of three and they go back farther.
04-14-2018, 01:09 PM
Replies: 13
Views: 3,494
Posted By spinkick

what makes these different than the protekt...

what makes these different than the protekt plates? What are the ridges for in these? I like the protekt ones because everything is countersunk, no bolts to get caught or silicone to fill spaces....
04-14-2018, 08:13 AM
Replies: 13
Views: 3,494
Posted By JerryU

Yep, Scrape Armor supplied the black silicone and...

Yep, Scrape Armor supplied the black silicone and I used a small amount in two places. But the majority fit just fine and the only thing that would see the tight seam would be an ant! I felt no...
04-14-2018, 07:39 AM
Replies: 13
Views: 3,494
Posted By robertbruce

[QUOTE=JerryU;1596993945]Yep, since my above post...

[QUOTE=JerryU;1596993945]Yep, since my above post i tested mine! Not intentionally! :lol:
...
04-13-2018, 10:13 PM
Replies: 13
Views: 3,494
Posted By JerryU

Yep, since my above post i tested mine! Not...

Yep, since my above post i tested mine! Not intentionally! :lol:
...
03-17-2018, 03:19 PM
Replies: 11
Views: 685
Posted By Dano523

Passenger side gets a jute pad so it allows the...

Passenger side gets a jute pad so it allows the air bag system to stay shut off when you have a baby seat in it. Hence there is a seat pressure sensor under the pad, and without it, the wires would...
Showing results 1 to 25 of 80
 


 
Forum Jump

Sponsored Ads
Vendor Directory

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service

© 2018 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.