CorvetteForum - Chevrolet Corvette Forum Discussion - Search Results


Showing results 1 to 25 of 317
Search took 0.47 seconds.
Search: Posts Made By: Antz81
Forum: C3 Tech/Performance 10-14-2017, 03:33 PM
Replies: 11
Views: 318
Posted By Antz81
have you checked the support frame around the...

have you checked the support frame around the headlights? I had the same issue as you, and no adjustment could get them high enough. The front mounting tabs are known to break off.
Forum: C3 Tech/Performance 10-13-2017, 07:59 PM
Replies: 8
Views: 253
Posted By Antz81
I assume this is on an 81? If so the ecm won't...

I assume this is on an 81?
If so the ecm won't like the bigger cam. No point going back to the ccc setup. Just tidy it up and enjoy it.
The gauges are all independent of the ecm, so you can remove...
Forum: C3 General 10-08-2017, 07:51 PM
Replies: 4
Views: 199
Posted By Antz81
if you don't get these readings at the battery...

if you don't get these readings at the battery check for them at the alternator just to be sure it's not a broken cable
Forum: C3 Tech/Performance 10-07-2017, 02:14 PM
Replies: 5
Views: 134
Posted By Antz81
Give it a good look over first. Mine looked great...

Give it a good look over first. Mine looked great (mostly) when I replace it. There was just one track in the corner that had lifted, it was almost about to create a short. Even in my photos of it...
Forum: C3 Tech/Performance 10-06-2017, 07:30 PM
Replies: 5
Views: 134
Posted By Antz81
You need to remove the tach from the other side...

You need to remove the tach from the other side then you should be able to see how they clip in.
Forum: C3 Tech/Performance 10-06-2017, 02:43 PM
Replies: 7
Views: 269
Posted By Antz81
Remove the fuel flap (4 screws around the outside...

Remove the fuel flap (4 screws around the outside from memory)
Remove the fuel cap and rubber filler boot. From there you should be able to see top of the sensor unit. On an 82 this will have the...
Forum: C3 Tech/Performance 10-06-2017, 02:21 PM
Replies: 10
Views: 272
Posted By Antz81
Also check The front left calliper doesn't have a...

Also check The front left calliper doesn't have a leak. My front right continued to leak after new seals were fitted, turns out it had a poorly fitted stainless sleeve and was leaking around the...
Forum: C3 Tech/Performance 10-06-2017, 02:17 PM
Replies: 7
Views: 269
Posted By Antz81
No need to drop the tank. You can get to if from...

No need to drop the tank. You can get to if from the top.
Forum: C3 Tech/Performance 10-05-2017, 12:40 PM
Replies: 4
Views: 211
Posted By Antz81
Just clean it off the pins if you choose to do...

Just clean it off the pins if you choose to do this. I do know that it's not Di-electric grease. It will be black like that on a brand new replacement harness as well.

I would say the problem is...
Forum: C3 General 10-04-2017, 11:44 PM
Replies: 6
Views: 204
Posted By Antz81
It is possible to swap the older iron diffs into...

It is possible to swap the older iron diffs into the 80-82 cars. There are quite a few other parts that need to be changed as well. (half shafts spindle flanges, strut rods, strut rod bracket, drive...
Forum: C3 Tech/Performance 10-04-2017, 11:34 PM
Replies: 4
Views: 211
Posted By Antz81
Not 100% on what it is, I believe it's for water...

Not 100% on what it is, I believe it's for water proofing.
I don't believe it will be causing the problem with your lights.
Forum: C3 General 09-30-2017, 02:55 PM
Replies: 15
Views: 403
Posted By Antz81
Code 23 is the mix control solenoid. check it...

Code 23 is the mix control solenoid.
check it for continuity, (plug is top of carb front left, should be around 10ohm from memory) if ok, check for power on the pink wire, with ignition on.
Forum: C3 General 09-29-2017, 04:22 PM
Replies: 21
Views: 1,071
Posted By Antz81
I'm not sure if it's someone with more money than...

I'm not sure if it's someone with more money than sense, or someone that likes a good challenge.
Forum: C3 General 09-28-2017, 12:30 PM
Replies: 5
Views: 291
Posted By Antz81
G I do not believe it is a corvette seat. ...

G

I do not believe it is a corvette seat.
I had the power seat out of my 81 just recently, if it was a corvette seat it should have studs on the bottom that pass through the floor.
The seat base...
Forum: C3 Tech/Performance 09-26-2017, 11:57 PM
Replies: 7
Views: 214
Posted By Antz81
Do those numbers match any part of the end of...

Do those numbers match any part of the end of your vin?
Maybe post a photo of the pad.
Forum: C3 Tech/Performance 09-26-2017, 11:53 PM
Replies: 48
Views: 1,231
Posted By Antz81
A mechanical pump won't work with the 82 unless...

A mechanical pump won't work with the 82 unless you've swapped the two throttle bodies out for a carb
Forum: C3 General 09-26-2017, 11:48 PM
Replies: 15
Views: 403
Posted By Antz81
Some of those vacuum lines are starting to look a...

Some of those vacuum lines are starting to look a little old, so may be starting to leak a little. I would put a proper cap on the one that just has a screw in it. Not sure why you have an empty port...
Forum: C3 Tech/Performance 09-19-2017, 01:31 PM
Replies: 9
Views: 247
Posted By Antz81
The ticking you hear is normal, the way the light...

The ticking you hear is normal, the way the light flashes is not. I'd just get them to swap the ecu. (I assume you trying to read codes at this point if not the ticking isn't normal either)
Forum: C3 General 09-18-2017, 01:26 PM
Replies: 20
Views: 583
Posted By Antz81
Can't remember which way they went in from but I...

Can't remember which way they went in from but I think if you look closely you'll see that they will only go in all the way from one direction. I can confirm later when I get into work. I used a...
Forum: C3 General 09-12-2017, 01:17 PM
Replies: 3
Views: 209
Posted By Antz81
I always found logging in gets rid of it

I always found logging in gets rid of it
Forum: C3 Tech/Performance 09-09-2017, 03:27 PM
Replies: 10
Views: 275
Posted By Antz81
As big bird said the original was copper clad...

As big bird said the original was copper clad aluminium. It can look fine, but be degraded internally. Should of gone with new copper, but there's always next time.
Forum: C3 Tech/Performance 09-08-2017, 04:33 PM
Replies: 8
Views: 199
Posted By Antz81
:lol: now it all makes sense. Glad it's all sorted

:lol: now it all makes sense. Glad it's all sorted
Forum: C3 Tech/Performance 09-08-2017, 03:07 PM
Replies: 8
Views: 199
Posted By Antz81
Do you mean the yoke on the diff or the trailing...

Do you mean the yoke on the diff or the trailing arm? Or is this on the half shaft itself?
The length of the half shafts changed for the 80-82 cars, they also have different u joints depending on...
Forum: C3 General 09-08-2017, 02:55 PM
Replies: 11
Views: 535
Posted By Antz81
Looking through your other thread I would replace...

Looking through your other thread I would replace the shocks, get the trailing arms rebuilt or replaced, swap the strut rods to adjustable rods. I would also check your brakes, it looks to me like...
Forum: C3 Tech/Performance 08-30-2017, 01:23 PM
Replies: 1
Views: 159
Posted By Antz81
No. The 80-82 strut rods are different. When...

No. The 80-82 strut rods are different. When mounted the inner end sits slightly to the rear of the outer end and the strut rod is built to match this.
The 68?-79 strut rods are straight, and will...
Showing results 1 to 25 of 317

 
Forum Jump
Sponsored Ads
Vendor Directory

All times are GMT -4. The time now is 11:10 PM.