CorvetteForum - Chevrolet Corvette Forum Discussion - Search Results

Notices
 
Search: Posts Made By: Space387
Showing results 1 to 25 of 192
Search took 0.16 seconds.
06-22-2018, 09:38 PM
Replies: 22
Views: 367
Posted By Space387

rwobs no the pump did NOT run at all. There was...

rwobs no the pump did NOT run at all. There was voltage only with the circuit open and no pump attached. The easiest and most effective way do fix this is to systematically start from the pump and...
06-22-2018, 08:57 PM
Replies: 22
Views: 367
Posted By Space387

The test for the fuse was done first with the ...

The test for the fuse was done first with the fuse in place than with the multi-meter AS the fuse. Second when I gave 12V and 0.9V under prime the difference as noted was if I had the pup in the...
06-22-2018, 05:44 PM
Replies: 22
Views: 367
Posted By Space387

I pulled all 3 relays under the passenger side...

I pulled all 3 relays under the passenger side dash and bench tested them to find they all work and carry current. I don't hear it engaging under the dash so now to see why its not going that.
06-22-2018, 04:32 PM
Replies: 22
Views: 367
Posted By Space387

Looking at the schematics and being an amature at...

Looking at the schematics and being an amature at best in electrical engineering, I am confused as to how exactly the oil safety switch will prevent the car from powering the fuel pump. I see there...
06-22-2018, 03:48 PM
Replies: 22
Views: 367
Posted By Space387

1v fuse to ground during prime remove the fuse...

1v fuse to ground during prime
remove the fuse and probe pole to pole the fuse slot is 12v during prime
06-22-2018, 02:37 PM
Replies: 22
Views: 367
Posted By Space387

Just because I am not seeing the err in my ways...

Just because I am not seeing the err in my ways at this point. You are asking to test for voltage between the black(ground) and chassis/ battery ground with the pump plugged in during the prime...
06-22-2018, 02:08 PM
Replies: 22
Views: 367
Posted By Space387

when testing for voltage I am using the power in...

when testing for voltage I am using the power in and the ground at the plug on top of the tank. When I tested the pump in the tank by bypassing the entire switch system I had ran both 12V+ and Grnd...
06-22-2018, 12:36 PM
Replies: 22
Views: 367
Posted By Space387

At this time I have tested Voltage at the input...

At this time I have tested Voltage at the input plug, 12-11.8V during prime and 10.8V during crank. New and old pump spin up properly when ran directly from the battery and from through the pump...
06-22-2018, 12:27 PM
Replies: 1
Views: 76
Posted By Space387

what year and engine? what trans? Any lights on?(...

what year and engine? what trans? Any lights on?( security solid) any codes?
06-20-2018, 10:56 PM
Replies: 22
Views: 367
Posted By Space387

Got DTC 46, Vats error, and 56, low fuel pressure...

Got DTC 46, Vats error, and 56, low fuel pressure voltage.

So here is where we stand. The Vats system was just being a pain and needed to sit for a little bit. Now the engine cranks and sputtered...
06-20-2018, 10:38 PM
Replies: 22
Views: 367
Posted By Space387

looking head on with the vertical tab up the A...

looking head on with the vertical tab up the A pin is top left or top right?
06-20-2018, 09:39 PM
Replies: 22
Views: 367
Posted By Space387

L98 No Start

So I am having a no start issue with my 1990 L98.

It started and ran fine with out any lights about 4 days ago. This morning I went to start it up and she would turn over but not fire. After a few...
06-19-2018, 08:23 AM
Replies: 11
Views: 421
Posted By Space387

Once the shim is checked dont over look all the...

Once the shim is checked dont over look all the engine grounds. I had one of the 2 block straps off on my LT1, went through 1 reman original and a high tq yo find I was overloading the ground.
06-14-2018, 07:07 AM
Replies: 15
Views: 440
Posted By Space387

No MAF on a 1990 and at idle and lower rpm there...

No MAF on a 1990 and at idle and lower rpm there is no decernable vibration over the inherent vibrations of a SBC
06-12-2018, 01:48 AM
Replies: 15
Views: 440
Posted By Space387

The vibration may have been for as long as I have...

The vibration may have been for as long as I have owned the car but I was restraining from working the engine until I had some miles on it to be sure there where no gremlins waiting for me. Records...
06-09-2018, 10:58 PM
Replies: 15
Views: 440
Posted By Space387

I will get the coolant pressure tester on my next...

I will get the coolant pressure tester on my next few days off. I would pull the motor to rebuild before adding any of the snake oil magic fixes to this car, I have seen it damage too many cars by...
06-09-2018, 01:46 PM
Replies: 15
Views: 440
Posted By Space387

I am not sure if the flywheel stock or...

I am not sure if the flywheel stock or aftermarket as the prior owners had the transmission replaced with a new ZF and it is not clear if they changed it then or with the clutch change. I did find...
06-09-2018, 09:07 AM
Replies: 15
Views: 440
Posted By Space387

Yes it vibrates when stationary at the same RPM...

Yes it vibrates when stationary at the same RPM and is independent of the the vehicle speed not quite as severe in my driveway, I figured this was related the the effort required to get to these...
06-08-2018, 11:55 PM
Replies: 15
Views: 440
Posted By Space387

High RPM vibrations

So I went to mexico today with my corvette for the first time and had a disturbing discovery. When I spin out the engine I feel a vibration come on thats not present at lower speeds. To be exact its...
06-04-2018, 10:16 PM
Replies: 57
Views: 5,559
Posted By Space387

I saw the wing update pic and thought you put...

I saw the wing update pic and thought you put Leroy up for a second. Nice work
06-04-2018, 09:47 PM
Replies: 17
Views: 636
Posted By Space387

To clear things up tramlining is? Is that...

To clear things up tramlining is?

Is that the effect of following the trenches in the road set by wear and heavy vehicles? If so I never new there was a name for it. For what its worth I just put...
05-29-2018, 09:20 PM
Replies: 1
Views: 146
Posted By Space387

Found the answer to my own question. From 84-89...

Found the answer to my own question. From 84-89 the resistor is required. For 90-95 no resistor is required or recommended as it can cause damage.
05-29-2018, 07:24 PM
Replies: 3,845
Views: 256,079
Posted By Space387

Had to pull the MAP sensor to use on my daily...

Had to pull the MAP sensor to use on my daily until a new one comes in. Perk of having a daily from the same era I guess
05-27-2018, 12:37 AM
Replies: 1
Views: 146
Posted By Space387

Data logging

I have a cable built for reading and writing my LT1 Firebird PCM. I want to start data logging my corvette and just want to be sure there is nothing missing or different. I remember reading long ago...
05-26-2018, 06:58 PM
Replies: 0
Views: 166
Posted By Space387

What if I remove the ECM?

In looking into my options for building power one screaming detail comes to mind, how to conduct this 8 piece symphony?
There is the stock ECM that I'm sure has it's benefits and limitations, and a...
Showing results 1 to 25 of 192
 


 
Forum Jump

Sponsored Ads
Vendor Directory