CorvetteForum - Chevrolet Corvette Forum Discussion - Search Results

Notices
 
Search: Posts Made By: 383vett
Showing results 1 to 25 of 496
Search took 1.21 seconds.
Forum: Drag Racing
Yesterday, 08:35 PM
Replies: 2
Views: 102
Posted By 383vett

Someone here was working on one the last year or...

Someone here was working on one the last year or two. I don't think he posted his final results but he was gathering parts.
Yesterday, 08:17 PM
Replies: 4
Views: 96
Posted By 383vett

I would. Others may disagree. I used to run a...

I would. Others may disagree. I used to run a 58mm on a 383 with good results.
Yesterday, 06:17 PM
Replies: 14
Views: 512
Posted By 383vett

If they had tested an A8 ZR1 in the quarter, the...

If they had tested an A8 ZR1 in the quarter, the time should have been at least a half second faster than the M7 they ran for the article.
Yesterday, 10:45 AM
Replies: 10
Views: 271
Posted By 383vett

Thanks again. First round I had a .024 against a...

Thanks again. First round I had a .024 against a .012. The car didn't run it's number and I was out early to watch fireworks. :ack:
07-16-2018, 01:38 PM
Replies: 7
Views: 338
Posted By 383vett

Go with Rich at Abel. It will be done correctly.

Go with Rich at Abel. It will be done correctly.
07-16-2018, 01:30 PM
Replies: 11
Views: 382
Posted By 383vett

Over the years, I've had 2 sets of 2151 Hooker...

Over the years, I've had 2 sets of 2151 Hooker headers. They do fit.
07-14-2018, 02:33 PM
Replies: 13
Views: 312
Posted By 383vett

I wouldn't worry about an alternator blowing up....

I wouldn't worry about an alternator blowing up. I've seen hundreds of motors blow at the track and have never seen or heard of an alternator blowing.
07-14-2018, 02:27 PM
Replies: 8
Views: 253
Posted By 383vett

I did that to my 84 years ago. Having a factory...

I did that to my 84 years ago. Having a factory service manual was invaluable. You need a vacuum HEI distributor, a low profile intake, carb and a lot of time. I didn't hack anything when I did the...
07-14-2018, 12:17 PM
Replies: 10
Views: 271
Posted By 383vett

Thanks all! :thumbs:

Thanks all! :thumbs:
07-13-2018, 05:37 PM
Replies: 17
Views: 420
Posted By 383vett

Just wondering, if oil is getting past the rings...

Just wondering, if oil is getting past the rings due to a bad oil ring, how can that cylinder look clean? Are you sure you aren't confusing this with another situation where you may have had coolant...
07-13-2018, 01:22 PM
Replies: 10
Views: 271
Posted By 383vett

000 light

Thought I would post a time slip of my first time run last 4th of July. Lightening does strike once in a...
07-13-2018, 01:08 PM
Replies: 17
Views: 420
Posted By 383vett

As 2 others have mentioned, do a leakdown test. ...

As 2 others have mentioned, do a leakdown test. It'll show you the health or sickness of all the cylinders. Why would you replace all those parts trying to figure out the problem when a simple test...
07-12-2018, 05:54 PM
Replies: 16
Views: 710
Posted By 383vett

It's purpose is to hold a MSD box....

It's purpose is to hold a MSD box. https://cimg2.ibsrv.net/gimg/www.corvetteforum.com-vbulletin/640x480/002_ebabdc58c069a730c086465fcf03c2f40040458e.jpg
07-12-2018, 11:50 AM
Replies: 6
Views: 399
Posted By 383vett

Try an 84 with a 5 point rollbar.

Try an 84 with a 5 point rollbar.
07-11-2018, 10:37 PM
Replies: 17
Views: 393
Posted By 383vett

That's a low 13 second run. ...

That's a low 13 second run. Nicehttp://cochise.uia.net/pkelley2/eight-to-quarter.htm
07-10-2018, 11:07 AM
Replies: 20
Views: 5,186
Posted By 383vett

Cloyes True Roller here to add to this 10 year...

Cloyes True Roller here to add to this 10 year old thread.
07-10-2018, 10:43 AM
Replies: 15
Views: 12,491
Posted By 383vett

That's why Kman has been off this forum for 7...

That's why Kman has been off this forum for 7 years and is driving a Yugo.
07-10-2018, 01:00 AM
Replies: 3
Views: 128
Posted By 383vett

Normally a leak in the areas you mentioned would...

Normally a leak in the areas you mentioned would be accompanied with a loss of oil. Why don't you do a smoke test with the engine off and the source of the leak should be easily detected?
07-09-2018, 08:23 PM
Replies: 18
Views: 276
Posted By 383vett

When an ignition module goes out, the classic...

When an ignition module goes out, the classic example is the car dying when hot. Although not always a fan of parts swapping, you might want to change out the ignition module. It's a really easy...
07-09-2018, 02:27 PM
Replies: 241
Views: 20,412
Posted By 383vett

You finally got rid of the misfire! ...

You finally got rid of the misfire! Congratulations. That's been a problem for you for what seems like ages.
07-09-2018, 02:21 PM
Replies: 21
Views: 551
Posted By 383vett

Thank you. I'll be giving you a call soon.

Thank you. I'll be giving you a call soon.
07-09-2018, 01:29 PM
Replies: 2
Views: 269
Posted By 383vett

I have a 2016 Z06 that had the shudder. It has...

I have a 2016 Z06 that had the shudder. It has been pretty much resolved with the triple flush that was performed last year.
07-09-2018, 12:06 PM
Replies: 21
Views: 551
Posted By 383vett

And GM also cannot based on information provided...

And GM also cannot based on information provided to them by the dealer?
07-09-2018, 12:00 PM
Replies: 241
Views: 20,412
Posted By 383vett

I did pretty much the same thing with my...

I did pretty much the same thing with my Granatelli tank. I used a longer hose though, maybe 1.5". In cold weather, the hose is pretty stiff and needed to be warmed in front of a heater to fit over...
07-09-2018, 11:17 AM
Replies: 21
Views: 551
Posted By 383vett

That is the million dollar question. Dave,...

That is the million dollar question. Dave, recently you posted a thread asking for information on how to access the ecm because of "issues" you were having. Prior to that, in another thread you...
Showing results 1 to 25 of 496
 


 
Forum Jump

Sponsored Ads
Vendor Directory

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.