CorvetteForum - Chevrolet Corvette Forum Discussion - Search Results

Notices
 
Search: Posts Made By: MCK_Z06
Showing results 1 to 25 of 119
Search took 0.12 seconds.
07-18-2018, 03:35 PM
Replies: 9
Views: 453
Posted By MCK_Z06

LG Motorsports makes a nice extraction hood. ...

LG Motorsports makes a nice extraction hood.
That being said LG just installed the ACS extractor kit mentioned above for me with a few changes.
I already had their race fan. They left the inner...
07-18-2018, 03:07 PM
Replies: 32
Views: 3,565
Posted By MCK_Z06

I have had the car back for about a month with...

I have had the car back for about a month with the kit installed and tuned and no issues to report just put gas or E85 in and drive. (No meth)
I made about the same power on 93pump (low 700rwhp) as...
07-13-2018, 01:55 PM
Replies: 15
Views: 1,593
Posted By MCK_Z06

All items have been sold!

Moderators please close or delete this post as all items have been sold.

Thanks!
07-13-2018, 01:52 PM
Replies: 1
Views: 108
Posted By MCK_Z06

Moderators please close or delete this post.

Moderators please close or delete this post.
I was able to get one locally.

Thanks!
07-05-2018, 05:27 PM
Replies: 1
Views: 108
Posted By MCK_Z06

Cover Asm-Instrument Panel Steering Column Upper Trim

Looking to purchase the following ASAP.
New or Used.

GM Part No.: 22826767 OR: 23206803
Cover Asm-Instrument Panel Steering Column Upper Trim *Black

Part Description
COVER
Other Name...
06-29-2018, 02:16 PM
Replies: 30
Views: 2,801
Posted By MCK_Z06

From: https://www.hptuners.com/vehicles/ ...

From: https://www.hptuners.com/vehicles/
14-16Corvette 6.2
17-18Corvette 6.2
19 Corvette 6.2 (Non-ZR1)
06-26-2018, 08:13 PM
Replies: 14
Views: 426
Posted By MCK_Z06

What Jeff said. port injection is normally...

What Jeff said. port injection is normally installed as a secondary system on these cars.
On mine under normal driving conditions it only runs on the DI system.

Once I get into boost or a certain...
06-26-2018, 08:02 PM
Replies: 22
Views: 1,392
Posted By MCK_Z06

Because they all use the same valve covers. On...

Because they all use the same valve covers. On the dry sump cars the cap is just to cover the hole.
It cannot be removed without removing the clip installed on the back. It will only moves like 1/2...
06-25-2018, 08:59 PM
Replies: 80
Views: 6,871
Posted By MCK_Z06

The inner front wheel well is right behind the...

The inner front wheel well is right behind the HX's and it has a directional vent that directs the air out the wheel well.
Is that what you were asking?
06-23-2018, 08:51 PM
Replies: 14
Views: 791
Posted By MCK_Z06

Thought I would follow up after I got it...

Thought I would follow up after I got it installed.
The wheel was defect/damage free and is a huge improvement.

Much more comfortable than the stock D shaped wheel no matter where you are holding...
06-23-2018, 03:55 PM
Replies: 18
Views: 677
Posted By MCK_Z06

I have seen a few different cars with this hood...

I have seen a few different cars with this hood on random Instagram postings but I have no clue who owns them.
They may not hang out on this forum much or at all?
06-23-2018, 12:23 AM
Replies: 7
Views: 310
Posted By MCK_Z06

I got to check these out today. They are light...

I got to check these out today. They are light for how huge they are.
You cant really tell form the picture above but they are vented all the way through around the pistons which I though was a cool...
06-20-2018, 04:39 PM
Replies: 27
Views: 792
Posted By MCK_Z06

You just plug it into your OBD-II port. The...

You just plug it into your OBD-II port.
The gauges are setup using your PC and a USB cable. The gauges are displayed on the factory navigation screen, no mounting of anything.
Just select with your...
06-18-2018, 11:50 PM
Replies: 15
Views: 595
Posted By MCK_Z06

Oh, just loosen/remove the plastic tube between...

Oh, just loosen/remove the plastic tube between the airbox and the throttle body and see if there is oil inside. I just meant "peek" like don't tilt it up to the light on the ceiling and put you eye...
06-18-2018, 09:20 PM
Replies: 15
Views: 595
Posted By MCK_Z06

Take a peek in your intake tube. (especially...

Take a peek in your intake tube.
(especially the little "reservoir" on the side with the PCV/vacuum tube connected.)

Be careful removing... if that's where the oil is going it can retain quite a...
06-18-2018, 11:09 AM
Replies: 24
Views: 2,110
Posted By MCK_Z06

Very cool! Were they shooting for the MT YouTube...

Very cool! Were they shooting for the MT YouTube series?



Toyo R888R's.
06-17-2018, 01:03 PM
Replies: 83
Views: 6,094
Posted By MCK_Z06

You did an awesome build all the way around. I...

You did an awesome build all the way around. I love how clean everything was routed etc.
Looks like you are running about 10 degrees cooler for Water & Oil than I am with the LG setup under similar...
06-17-2018, 12:44 PM
Replies: 26
Views: 1,561
Posted By MCK_Z06

Is that your Dyno sheet? That dyno sheet is...

Is that your Dyno sheet?
That dyno sheet is from a shop down the road from me in McKinney, Texas.
If Sean or Clint said there was a 16whp gain from a TB swap then I would believe them as they...
06-17-2018, 11:38 AM
Replies: 26
Views: 1,561
Posted By MCK_Z06

Yeah, and 30-50HP of that 63HP is from the tune...

Yeah, and 30-50HP of that 63HP is from the tune alone.
A popular "Stage 1 Package" a lot of shops have is CAI + Long Tube Headers and a tune. This seems to pretty consistently produce 40-60RWHP.
...
06-16-2018, 11:32 PM
Replies: 14
Views: 791
Posted By MCK_Z06

^^^ I believe this is a Deity Motorsports...

^^^ I believe this is a Deity Motorsports wheel... but I could be wrong.
It also looks like its thicker than the other wheels which I thought I saw as an option on the Apsis wheels too.
06-16-2018, 09:22 PM
Replies: 14
Views: 791
Posted By MCK_Z06

Humm... as much as this stuff costs I would want...

Humm... as much as this stuff costs I would want it to be perfect personally.
Especially something that you see and touch every time you drive.

Have you tried to PM him on here?
06-16-2018, 09:15 PM
Replies: 13
Views: 771
Posted By MCK_Z06

I think it was probably 1 hour because they...

I think it was probably 1 hour because they already had the fenders opened up and things moved out of the way to get to the gas tank. But yes I feel like it was worth it to have them do this.

Yes,...
06-16-2018, 07:19 PM
Replies: 14
Views: 791
Posted By MCK_Z06

Thanks for the info. Now you have me worried... ...

Thanks for the info. Now you have me worried...
I guess I'll find out Monday when it gets here. Its always hard to tell from pictures when its on a table and there are shadows etc.

Did you get...
06-16-2018, 07:01 PM
Replies: 14
Views: 791
Posted By MCK_Z06

Jersey, that came out awesome! I cant wait to get...

Jersey, that came out awesome! I cant wait to get it installed.
06-16-2018, 06:28 PM
Replies: 13
Views: 771
Posted By MCK_Z06

I have real Carbon Fiber vents. These are whole...

I have real Carbon Fiber vents. These are whole carbon pieces (not an overlay over the factory part.) They are so light they feel like they are made of cardboard compared to the stock pieces.
...
Showing results 1 to 25 of 119
 


 
Forum Jump

Sponsored Ads
Vendor Directory

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.