CorvetteForum - Chevrolet Corvette Forum Discussion - Search Results

Notices
 
Search: Posts Made By: bocallaghan
Showing results 1 to 25 of 53
Search took 0.55 seconds.
08-28-2011, 08:27 PM
Replies: 10
Views: 17,334
Posted By bocallaghan

Thanks for the posts! I was able to replace the...

Thanks for the posts! I was able to replace the drive belt but couldn't get the replacement ac belt on. I went ahead and re-used the old ac belt due to the fact that it wasn't frayed. I will...
08-28-2011, 10:56 AM
Replies: 10
Views: 17,334
Posted By bocallaghan

C6 serpentine belt replacement

Yesterday the belt that goes around my alternator, water pump and power steering etc. came off. Can someone please give me some pointers before I tackle this task?

Thanks!
07-29-2011, 05:51 PM
Replies: 1
Views: 266
Posted By bocallaghan

Next Mod/Upgrade

Okay, so all I have is rims, borla's, and a vararam cai. What should my next performance modification be? I've seen bad reviews on the aftermarket MAF sensor and was looking to spend about...
02-21-2011, 03:52 PM
Replies: 20
Views: 10,112
Posted By bocallaghan

oil pressure sensor

Did you ever get this done on your car? My pressure gauge is pegged and I have to change my sensor too. The only detailed drawings I'm finding are for the C5. I do not want to start cutting on my...
02-18-2011, 12:21 PM
Replies: 1
Views: 293
Posted By bocallaghan

Good Body shop???

Okay so yesterday someone decided to run into the side of my car while driving. The door and rear quarter panel are both damaged (scraps, and cracks). The majority of the damage is inside the door...
01-21-2011, 07:40 PM
Replies: 11
Views: 1,668
Posted By bocallaghan

Okay so I found the problem. Knob Jockey was...

Okay so I found the problem. Knob Jockey was correct. This may work for others that are having a similar issue. I opened the top and left the back hatch up. On the passenger side area, where the...
01-21-2011, 07:31 PM
Replies: 1
Views: 1,155
Posted By bocallaghan

Nevermind, I found the answer to my question. ...

Nevermind, I found the answer to my question.

It takes synthetic gear oil 70W90.
01-21-2011, 06:00 PM
Replies: 1
Views: 1,155
Posted By bocallaghan

Type of fluid in a 06 convertible top motor

Do I use hydraulic fluid? If so is there a specific kind or brand recommended? I've heard some cars take transmission fluid and I want to make sure this isn't one.

Thanks,
Chris
01-18-2011, 09:37 AM
Replies: 11
Views: 1,668
Posted By bocallaghan

Wow thanks for all the feedback. I don't know...

Wow thanks for all the feedback. I don't know what I'd do without all this experience you all bring to the table. I'll keep you posted on what happens.

Thanks again!
01-12-2011, 09:35 PM
Replies: 11
Views: 1,668
Posted By bocallaghan

Motorized Convertible Top Issue

My C6 top is having trouble dropping the top and returning it back to the up position. To put the top down and up I have to move the window out the way and guide the top cover up. The hatch that...
12-21-2010, 09:15 PM
Replies: 11
Views: 877
Posted By bocallaghan

High Oil Pressure Reading

So I noticed on my car tonight that my oil pressure gauge was pegged down below the 80 on my instrument panel. I scrolled through the diagnostics and noticed I had a reading of 130 psi that...
11-24-2010, 04:48 PM
Replies: 10
Views: 386
Posted By bocallaghan

Oh okay, I misread your first post, I thought you...

Oh okay, I misread your first post, I thought you meant that my rear tires were currently at at 27.2" diameter. Your two tires sizes is exactly the information that I'm looking for. Thank you so...
11-24-2010, 03:21 PM
Replies: 10
Views: 386
Posted By bocallaghan

hmmm I wonder why I'm having problems. It only...

hmmm I wonder why I'm having problems. It only happens at a speed of roughly 65mph and above. The traction control active light comes on at these speeds and I have to turn off the TC to remove the...
11-24-2010, 09:20 AM
Replies: 10
Views: 386
Posted By bocallaghan

I have 255 30ZR 20's on the front. Thanks.

I have 255 30ZR 20's on the front.

Thanks.
11-22-2010, 12:25 PM
Replies: 10
Views: 386
Posted By bocallaghan

Calculating tire size adjustments

So I have aftermarket rims on my car and the change in tire and rim size to 20's all around has altered my traction control at higher speeds. I have 305 25ZR 20's on the rear. I don't want them any...
11-19-2010, 11:33 PM
Replies: 0
Views: 216
Posted By bocallaghan

needing new tires

So I have aftermarket rims on my car and the change in tire and rim size to 20's all around has altered my traction control at higher speeds. I have 305 25R 20's on the rear. I don't want them any...
11-04-2010, 03:21 PM
Replies: 3
Views: 706
Posted By bocallaghan

Ok I'm going to see if I can find a shop that can...

Ok I'm going to see if I can find a shop that can do this for me. Any suggestions?
11-04-2010, 10:32 AM
Replies: 3
Views: 706
Posted By bocallaghan

Service Tire Monitoring System

I put new tires on my aftermarket rims and Discount Tire couldn't recalibrate my tire sensors. For some reason they could only get one to work. I was told that I had to get them recalibrated with a...
11-04-2010, 10:25 AM
Replies: 7
Views: 827
Posted By bocallaghan

So I just wanted to thank everyone for their...

So I just wanted to thank everyone for their input. Apparently changing the "smart" fuse and replacing it with a standard fuse with the CAGS hookup worked. Again thanks!
11-03-2010, 03:19 PM
Replies: 7
Views: 827
Posted By bocallaghan

ok I'll start by placing a standard fuse under...

ok I'll start by placing a standard fuse under the hood. The resister on the CAGS eliminator looked ok but I will check it again to see if it's bad or needs replacing

thanks!
Forum: Off Topic
11-03-2010, 09:38 AM
11-03-2010, 08:37 AM
Replies: 7
Views: 827
Posted By bocallaghan

I did buy it used. So replacing the blown smart...

I did buy it used. So replacing the blown smart fuse won't fix the problem. I thought I could get a new fuse and a new cags eliminator to see if that would work.
11-01-2010, 01:11 PM
Replies: 7
Views: 827
Posted By bocallaghan

Service Engine Light P0803

Ok so I had my system ran and I have P0803 error code (1-4 upshift solenoid circuit). I disconnected the CAGS eliminator under the car and hooked it back up stock. I then had the code erased and it...
11-01-2010, 01:01 PM
Replies: 23
Views: 2,916
Posted By bocallaghan

yea me too! Erasing and reprogramming the fob...

yea me too! Erasing and reprogramming the fob went flawless. Now it's time to work on this service engine light for the skip shift.
10-31-2010, 05:22 PM
Replies: 23
Views: 2,916
Posted By bocallaghan

Ok so I finally got it to work. Apparently...

Ok so I finally got it to work. Apparently rolling the windows down, stick in reverse, and dropping the top worked for me. I doubt the top had anything to do with it, but I was able to use the turn...
Showing results 1 to 25 of 53
 


 
Forum Jump

Sponsored Ads
Vendor Directory

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.