CorvetteForum - Chevrolet Corvette Forum Discussion - Search Results

Notices
 
Search: Posts Made By: '75
Showing results 1 to 25 of 491
Search took 1.85 seconds.
Yesterday, 10:51 PM
Replies: 3
Views: 108
Posted By '75

The mounting of the relay needs to be grounded.

The mounting of the relay needs to be grounded.
Yesterday, 10:48 PM
Replies: 11
Views: 255
Posted By '75

The one with the jumper goes to the A6...

The one with the jumper goes to the A6 compressor, the other plug goes to the pressure switch on the liquid line inside the right fender lip.
Forum: C3 General
Yesterday, 10:35 PM
Replies: 84
Views: 4,036
Posted By '75

Very nice work and moving along fast too! ...

Very nice work and moving along fast too!

Dean
Forum: C3 General
Yesterday, 08:19 PM
Replies: 7
Views: 171
Posted By '75

I used the knock-out like listed above for the...

I used the knock-out like listed above for the crankcase vent. This is a 14" air cleaner, it clears the HEI, but it's close....
02-17-2019, 06:41 PM
Replies: 10
Views: 545
Posted By '75

:iagree: Is the return line entering the...

:iagree: Is the return line entering the reservoir below the fluid level, if close to or above the fluid level it could be causing aeration/foaming of the fluid.
02-17-2019, 06:22 PM
Replies: 5
Views: 250
Posted By '75

Remove the brake caliper and then the outer wheel...

Remove the brake caliper and then the outer wheel bearing. Slip the whole rotor/hub off together and replace the studs. The ground off rivets won't hurt anything.
Forum: C3 General
02-17-2019, 05:00 PM
Replies: 3
Views: 210
Posted By '75

As long as the bearings are still a press fit, I...

As long as the bearings are still a press fit, I wouldn't be afraid to use it.
Forum: C3 General
02-17-2019, 12:37 PM
Replies: 2
Views: 182
Posted By '75

I always use a long piece of 5/8" all thread, not...

I always use a long piece of 5/8" all thread, not a spring compressor. I remove the shock, put the all thread up through the hole with a big washer and nut under the lower control arm and above the...
02-15-2019, 10:07 PM
Replies: 12
Views: 413
Posted By '75

The job can certainly be done as you describe...

The job can certainly be done as you describe without removing the rivets.
02-14-2019, 10:31 PM
Replies: 4
Views: 357
Posted By '75

PM sent.

PM sent.
Forum: C3 General
02-14-2019, 09:57 PM
Replies: 10
Views: 365
Posted By '75

Napa sells window removal wire, it works great to...

Napa sells window removal wire, it works great to saw through either butyl or urethane for getting the window out.
02-14-2019, 07:59 PM
Replies: 14
Views: 774
Posted By '75

I think using poly bushings requires the use of...

I think using poly bushings requires the use of the original bushing sleeves.
Forum: C3 General
02-10-2019, 10:07 PM
Replies: 4
Views: 262
Posted By '75

On AC cars there's a door there that closes it...

On AC cars there's a door there that closes it off when on Max AC so the cabin air is recirculated.
02-10-2019, 12:07 PM
Replies: 4
Views: 198
Posted By '75

Great tech resource and parts supplier!

Great tech resource and parts supplier!
02-10-2019, 12:01 PM
Replies: 6
Views: 245
Posted By '75

That should be the battery cable above the nut in...

That should be the battery cable above the nut in the tunnel, the fuel line should be on the right frame rail.
Forum: C3 General
02-09-2019, 05:45 PM
Replies: 9
Views: 358
Posted By '75

Click on his name and choose Mrvettes homepage

Click on his name and choose Mrvettes homepage
Forum: C3 General
02-09-2019, 05:39 PM
Replies: 3
Views: 236
Posted By '75

Could be anywhere, that antenna wasn't installed...

Could be anywhere, that antenna wasn't installed at the factory, so the fuse will be wherever the installer decided to put it. If he used one!
02-09-2019, 04:51 PM
Replies: 6
Views: 411
Posted By '75

Not much of a problem, just put it up on jack...

Not much of a problem, just put it up on jack stands, helps to have the rear higher than the front.
Forum: C3 General
02-05-2019, 08:53 PM
Replies: 9
Views: 443
Posted By '75

I went over this afternoon and inspected the car...

I went over this afternoon and inspected the car and found several issues. The first is the paint, it is very shiny single stage that looks great from 5 feet away. There are a few cracks in it, a...
Forum: C3 General
02-03-2019, 09:09 PM
Replies: 9
Views: 475
Posted By '75

Mine has asymmetrical arms, the front arms fold...

Mine has asymmetrical arms, the front arms fold to the rear for storage. I drive in most of the way, then push the rear arms under the car, drive in a little more and stop. The rear arms lift on the...
Forum: C3 General
02-02-2019, 11:46 PM
Replies: 9
Views: 443
Posted By '75

I just looked at the pictures, beautiful car. Pm...

I just looked at the pictures, beautiful car. Pm me your info, I assume you want it checked for the usual problem areas as far as rust and general condition, tire age, etc?

Dean
Forum: C3 General
02-02-2019, 11:11 PM
Replies: 9
Views: 443
Posted By '75

I live about 3 miles from there. Out of town...

I live about 3 miles from there. Out of town tomorrow, but I should be available to go over there Tuesday after work.
02-02-2019, 05:11 PM
Replies: 388
Views: 35,084
Posted By '75

:cheers::woohoo:

:cheers::woohoo:
02-02-2019, 04:04 PM
Replies: 388
Views: 35,084
Posted By '75

I was hoping that it was just poor lighting in...

I was hoping that it was just poor lighting in the photo and I was mistaken, but at least , like you say, the fix is easy at this point. All I would do is remove the shock, put a piece of all thread...
Forum: C3 General
02-01-2019, 10:58 PM
Replies: 2
Views: 143
Posted By '75

ttt

ttt
Showing results 1 to 25 of 491
 


 
Forum Jump

Sponsored Ads
Vendor Directory

Contact Us - About Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.