CorvetteForum - Chevrolet Corvette Forum Discussion - Search Results

Notices
Search: Posts Made By: Kingstonontario
Showing results 1 to 18 of 18
Search took 0.18 seconds.
06-06-2018, 06:52 PM
Replies: 12
Views: 417
Posted By Kingstonontario

I didn't think there was enough room to get it by...

I didn't think there was enough room to get it by the spring, but it just made it. I put an adjustable 12' wrench on it close as possible to the spring. With a bit of cranking it came loose. Thanks...
06-06-2018, 05:27 PM
Replies: 12
Views: 417
Posted By Kingstonontario

I'm not touching that 18mm bolt until I know...

I'm not touching that 18mm bolt until I know what's it for. I'm going to try a long ball hex extension with a pipe on the end. But I don't think there is enough clearance to get it in there. The...
06-06-2018, 02:44 PM
Replies: 6
Views: 554
Posted By Kingstonontario

I have moved this post to C6 tech/performance...

I have moved this post to C6 tech/performance only. Thanks everyone for your replies.
https://www.corvetteforum.com/forums/c6-tech-performance-101/
06-06-2018, 02:33 PM
Replies: 12
Views: 417
Posted By Kingstonontario

I did cut a small piece of 10mm Hex rod to fit...

I did cut a small piece of 10mm Hex rod to fit between the spring and 10mm Hex drain plug. (the max. length was 21mm to get it in there). Put a boxed end wrench on it with an extension and it...
06-06-2018, 10:16 AM
Replies: 12
Views: 417
Posted By Kingstonontario

The spring is right below the plug and about one...

The spring is right below the plug and about one inch clearance between them.
06-05-2018, 10:26 PM
Replies: 12
Views: 417
Posted By Kingstonontario

I jacked up the right rear and put it down on a...

I jacked up the right rear and put it down on a ramp to look at the plug. It was more covered than both wheels on the ground. So if I put both wheels up on ramps, I should get enough room to get to...
06-05-2018, 09:50 PM
Replies: 12
Views: 417
Posted By Kingstonontario

that's what I was thinking. But is there enough...

that's what I was thinking. But is there enough room to swing a wrench? The filler plug looks very easy to get to.
06-05-2018, 08:29 PM
Replies: 12
Views: 417
Posted By Kingstonontario

Rear Axle drain plug removal

There is no room to remove it. The Fiberglass spring is right on top of it. 2010 base model.
06-05-2018, 07:19 PM
Replies: 6
Views: 554
Posted By Kingstonontario

Rear Axle drain plug removal

There is no room to remove it. The Fiberglass spring is right on top of it. 2010 base model.
05-04-2018, 11:14 AM
Replies: 2
Views: 259
Posted By Kingstonontario

Cruse Control

Just bought this 2013 Corvette. The first time I went to use the cruse control, it didn't work. When I got home I checked the fuse box. There was no fuse in the spot for the cruse control, so I put...
03-30-2018, 08:49 PM
Replies: 1
Views: 241
Posted By Kingstonontario

Driver Info Center, C6

When I turn on the ignition the display reads "ACCESSORY MODE ON".When I press any of the DIC buttons, nothing happens. When I start the motor, ever thing works fine. Is this normal?
03-22-2018, 08:46 PM
Replies: 4
Views: 287
Posted By Kingstonontario

Does it's power turn off when the car is turned...

Does it's power turn off when the car is turned off? I would like to run a wire to the center console so I could put in a 12v plug that would loose it's power when the car is turned off.
03-22-2018, 05:49 PM
Replies: 4
Views: 287
Posted By Kingstonontario

Dash cam output power location

How do you power a Dash cam? The accessory power outlet in the center console is on all the time. I also have a GPS to plug in. I don't want to unplug them every time I turn the car off. 2013 C6.
03-17-2018, 08:46 PM
Replies: 17
Views: 919
Posted By Kingstonontario

When you removed it, what did you do with that...

When you removed it, what did you do with that wire that was attached to it?
03-17-2018, 08:19 PM
Replies: 17
Views: 919
Posted By Kingstonontario

I didn't remove it. I popped it off and looked at...

I didn't remove it. I popped it off and looked at it and then put it back on. Can I take it off without throwing a code? I want to put a Dash cam there.
03-17-2018, 06:22 PM
Replies: 17
Views: 919
Posted By Kingstonontario

Took it off, looked at it, put it back on. What...

Took it off, looked at it, put it back on. What hell is it?
03-17-2018, 04:48 PM
Replies: 17
Views: 919
Posted By Kingstonontario

Black box on windshield

I just bought a 2010 convertible base model. On the passenger side of the windshield at the top, there is a black box, 8"x2"x1". There is a wire going to it. What is it? I see nothing in the manual.
01-19-2018, 09:32 PM
Replies: 2
Views: 376
Posted By Kingstonontario

Exhaust

New to this form, just joined.Been lurking for two weeks. This site looks really great. Just bought my first Vet a couple of weeks ago. A 2010 base convertible six speed, 6600 Km, itís like mint. My...
Showing results 1 to 18 of 18


 
Forum Jump

Sponsored Ads
Vendor Directory

Contact Us - About Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.