CorvetteForum - Chevrolet Corvette Forum Discussion - Search Results

 
Search: Posts Made By: Bill Curlee
Showing results 1 to 25 of 500
Search took 1.72 seconds.
Forum: C5 Tech
Yesterday, 09:19 PM
Replies: 10
Views: 292
Posted By Bill Curlee

You are absolutely correct!! I was at work...

You are absolutely correct!!
I was at work and started to answer the post. Got called away for some BS work related crap and when I got back, I pressed the SEND button.. .You had already posted. ...
Forum: C5 Tech
Yesterday, 03:06 PM
Replies: 2
Views: 156
Posted By Bill Curlee

There are several relays inside the Door Control...

There are several relays inside the Door Control Module.
One is for LOCK and the other is UN-LOCK. Your UN-lock relay is going bad. You can check the relay for cold solder joints or for cracks and...
Forum: C5 Tech
Yesterday, 02:56 PM
Replies: 2
Views: 156
Posted By Bill Curlee

LOL!! The HEAT is normal but unwanted. We have...

LOL!! The HEAT is normal but unwanted. We have all experienced that issue. The tunnel gets very hot and GM didn't put very much insulation between the hot and inside of the cabin. I have a ZO6 and...
Forum: C5 Tech
Yesterday, 02:39 PM
Replies: 5
Views: 263
Posted By Bill Curlee

VALENTINE Radar Detector V1 What does the...

VALENTINE Radar Detector V1

What does the AMP do if you pull the fuse for the radio head?
Forum: C5 Tech
Yesterday, 02:28 PM
Replies: 7
Views: 257
Posted By Bill Curlee

I TOO, have a GM Factory 98 service manual set...

I TOO, have a GM Factory 98 service manual set and YES, they only came with THREE volumes. One of those volumes is thicker and contains the other volume for that year. The 97, 98 & 99 are VERY...
Forum: C5 Tech
Yesterday, 02:13 PM
Replies: 4
Views: 429
Posted By Bill Curlee

TIZZY If it happened to you ONCE,, It will...

TIZZY

If it happened to you ONCE,, It will happen again and when you least need it to.
Sounds like you have the latest GM Column Lock Recall which eliminated the steering column locking plate. ...
Forum: C5 Tech
Yesterday, 01:57 PM
Replies: 4
Views: 356
Posted By Bill Curlee

Be careful. If you replace the compressor, you...

Be careful. If you replace the compressor, you really should replace the receiver dryer and FLUSH all the other lines clean The receiver dryer is where any excess oil the system doesn't need...
Forum: C5 Tech
Yesterday, 01:52 PM
Replies: 11
Views: 353
Posted By Bill Curlee

IF,,, the male and female pins make proper...

IF,,, the male and female pins make proper contact with proper pin contact pressure, the grease is displaced and will work BUT,,, If the pins are weak and damaged/worn, that grease may just be enough...
Forum: C5 Tech
Yesterday, 01:49 PM
Replies: 14
Views: 949
Posted By Bill Curlee

I AGREE with TEXHAWK0. That is a very old issue...

I AGREE with TEXHAWK0. That is a very old issue and no longer effects modern batteries. NOT AN ISSUE!

Bill
Forum: C5 Tech
Yesterday, 01:47 PM
Replies: 14
Views: 949
Posted By Bill Curlee

The only way to tell if a battery has the proper...

The only way to tell if a battery has the proper CCA and Reserve Capacity is to fully charge it and have it properly load tested at the Auto Parts store or shop. Using a hydrometer to measure each...
Forum: C5 Tech
Yesterday, 01:30 PM
Replies: 11
Views: 353
Posted By Bill Curlee

In my experiences, that connector gets damaged...

In my experiences, that connector gets damaged easily and contact between the male and female pins gets crappy.
I STRONGLY DO NOT recommend putting dielectric grease in ANY connector.. Dielectric...
Forum: C5 Tech
Yesterday, 01:18 PM
Replies: 10
Views: 292
Posted By Bill Curlee

The vacuum actuators control the door dampeners...

The vacuum actuators control the door dampeners that make the air come out of selected vents CENTER HIGH, FLOOR, DEFROST etc..

The electric actuators control the temps. and select between heat...
Forum: C5 Tech
06-23-2019, 09:29 PM
Replies: 60
Views: 3,191
Posted By Bill Curlee

104 and 108 are the same ground point It turns...

104 and 108 are the same ground point It turns in to 108 on later models. Don't know why GM relabeled it as 104/108
Forum: C5 Tech
06-23-2019, 09:09 AM
Replies: 60
Views: 3,191
Posted By Bill Curlee

Under hood fuse box: ...

Under hood fuse box:

https://beta.photobucket.com/u/bill327/p/f89ad383-1ac2-4e36-9ff6-ff600b418f89
...
Forum: C5 Tech
06-23-2019, 08:28 AM
Replies: 21
Views: 835
Posted By Bill Curlee

DO NOT completely remove the bolt if the cooling...

DO NOT completely remove the bolt if the cooling system is HOT and PRESSURIZED!!! Just crack it a turn or two will usually be adequate to allow it to vent.
Forum: C5 Tech
06-22-2019, 05:29 PM
Replies: 21
Views: 835
Posted By Bill Curlee

https://img.photobucket.com/albums/v402/bill327/DS...

https://img.photobucket.com/albums/v402/bill327/DSCF0015-5.jpg

You can see the block off plug on the rear of this 2002

https://img.photobucket.com/albums/v402/bill327/C5Behindthemanifold.jpg
...
Forum: C5 Tech
06-22-2019, 05:16 PM
Replies: 21
Views: 835
Posted By Bill Curlee

You can just see it at the very top of this...

You can just see it at the very top of this picture:

https://smg.photobucket.com/user/bill327/media/C5STARConnecions.jpg.html

Here is an early style that runs under the intake 97-2000
...
Forum: C5 Tech
06-22-2019, 02:35 PM
Replies: 22
Views: 9,354
Posted By Bill Curlee

Don't pull it out!!!~~~~~~ You will never get it...

Don't pull it out!!!~~~~~~ You will never get it back in~!~ LOL!! Just flush it out with a garden hose
Forum: C5 Tech
06-21-2019, 03:49 PM
Replies: 4
Views: 271
Posted By Bill Curlee

NO FILTER on a C5. The air flow through the...

NO FILTER on a C5.

The air flow through the vents is controlled by vacuum actuated damper doors. If you don't have the proper vacuum signal, the damper doors will relax and the air will flow out...
Forum: C5 Tech
06-21-2019, 12:28 PM
Replies: 6
Views: 531
Posted By Bill Curlee

- BCM Wake/Sleep Issue:...

- BCM Wake/Sleep Issue: http://forums.corvetteforum.com/c5-tech/2719098-no-start-because-of-body-control-module.html ...
Forum: C5 Tech
06-21-2019, 12:25 PM
Replies: 10
Views: 436
Posted By Bill Curlee

READING YOUR Engine Diagnostic Codes ...

READING YOUR Engine Diagnostic Codes







The Diagnostic Display Mode is entered with the following procedure:
Forum: C5 Tech
06-21-2019, 12:21 PM
Replies: 2
Views: 284
Posted By Bill Curlee

I would first figure out what the HARD STOPS are...

I would first figure out what the HARD STOPS are on the C5. Are there stops on the wheel spindle or are there stops inside the cylinder?

Then look at the clearances between the tire and frame...
Forum: C5 Tech
06-21-2019, 12:13 PM
Replies: 5
Views: 331
Posted By Bill Curlee

I AGREE!! You beat me to it. Best asked in...

I AGREE!! You beat me to it.

Best asked in the Audio /Electronics section. Several stereo experts there!

BC
Forum: C5 Tech
06-21-2019, 12:11 PM
Replies: 6
Views: 904
Posted By Bill Curlee

Call Richard at Compliance parts. He will help...

Call Richard at Compliance parts. He will help you resolve it.
Forum: C5 Tech
06-21-2019, 12:07 PM
Replies: 6
Views: 531
Posted By Bill Curlee

When ever you disconnect and reconnect the...

When ever you disconnect and reconnect the battery, the BCM/PCm and other modules can and will throw random DTCs Just clear them and monitor.

BC
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - About Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.