CorvetteForum - Chevrolet Corvette Forum Discussion - Search Results

Notices
 
Search: Posts Made By: FYREANT
Showing results 1 to 25 of 484
Search took 0.63 seconds.
07-18-2019, 04:30 PM
Replies: 4
Views: 463
Posted By FYREANT

You don’t want to tap anywhere that will be...

You don’t want to tap anywhere that will be rounded. You need the tap location to be flat. Thats why I tapped it in a slightly different place than where the instructions showed
07-18-2019, 04:25 PM
Replies: 4
Views: 463
Posted By FYREANT

Hope these help. I drilled a little to the right...

Hope these help. I drilled a little to the right of the furthest right yellow dot in your pic
...
07-18-2019, 02:26 PM
Replies: 4
Views: 529
Posted By FYREANT

Pump is still available if youíre interested. Let...

Pump is still available if youíre interested. Let me know.
07-02-2019, 11:13 AM
Replies: 61
Views: 34,169
Posted By FYREANT

I replied to your PM. :thumbs: Ant

I replied to your PM. :thumbs:

Ant
06-27-2019, 07:42 PM
Replies: 32
Views: 14,408
Posted By FYREANT

Technically using HP Tuners to do anything to...

Technically using HP Tuners to do anything to your car is a warranty busting move.
06-25-2019, 01:36 PM
Replies: 13
Views: 1,356
Posted By FYREANT

^^This. Donít run 20+ psi on a stock compression...

^^This. Donít run 20+ psi on a stock compression motor. And by the way, the difference between those two piston options are not 10.5:1 and stock. Their actually 10.5:1 or 11.7:1 raising your...
06-16-2019, 01:36 PM
Replies: 15
Views: 1,311
Posted By FYREANT

Mine did this today. It was dead as a door and I...

Mine did this today. It was dead as a door and I hooked up the tender and it started clicking rapidly for about 5 min then stopped. Its now clicking once each 10-20 seconds or so. The battery is...
06-05-2019, 06:48 AM
Replies: 61
Views: 34,169
Posted By FYREANT

The guide was done with a wet sump

The guide was done with a wet sump
06-03-2019, 10:59 PM
Replies: 61
Views: 34,169
Posted By FYREANT

Any chevy dealer or chevy parts website will have...

Any chevy dealer or chevy parts website will have them. If they donít show the part numbers online then go down to your dealer and they can show you the diagram and get the part numbers
05-30-2019, 01:43 PM
Replies: 36
Views: 34,385
Posted By FYREANT

I think it is covered in the write up that Kracka...

I think it is covered in the write up that Kracka did. Should be linked on the first page under the other member how-toís for trans and diff fluid change. If I remember correctly I think he may cover...
05-27-2019, 10:52 AM
Replies: 10
Views: 5,780
Posted By FYREANT

I basically re-wrote the instructions when I did...

I basically re-wrote the instructions when I did my ďhow toĒ guide on the install. Have you seen that yet?
05-21-2019, 01:58 PM
Replies: 70
Views: 24,020
Posted By FYREANT

I wondered if thats what you meant. Yes, its...

I wondered if thats what you meant. Yes, its outlined on page 1, second part of step 44 (the text in Orange color). That is specific to the alignment of the A8.
05-21-2019, 01:47 PM
Replies: 70
Views: 24,020
Posted By FYREANT

There is a process outlined in the shop manual if...

There is a process outlined in the shop manual if I remember correctly. That would be part of a different how to guide though, not this one. Likely in drop in piston how to guide.
05-05-2019, 06:58 PM
Replies: 4
Views: 236
Posted By FYREANT

I wasn’t aware DSS made stub shafts. I though RPM...

I wasn’t aware DSS made stub shafts. I though RPM Transmission was the only one making those. Unless you are talking about the whole axle assembly and not just the stubs that stick out of the...
04-14-2019, 02:26 PM
Replies: 47
Views: 19,455
Posted By FYREANT

Basically, yes.

Basically, yes.
04-14-2019, 11:23 AM
Replies: 47
Views: 19,455
Posted By FYREANT

Iím sure I have pics somewhere but quite a while...

Iím sure I have pics somewhere but quite a while ago I switched to all polished engine bay covers.
04-13-2019, 01:17 PM
Replies: 15
Views: 767
Posted By FYREANT

Yea if I remember correctly its right there when...

Yea if I remember correctly its right there when you open the wheel well liner next to where the pump was.
04-10-2019, 02:08 PM
Replies: 15
Views: 767
Posted By FYREANT

Probably best to just replace the sensor. It...

Probably best to just replace the sensor. It can’t be too expensive.
04-10-2019, 02:00 PM
Replies: 5
Views: 246
Posted By FYREANT

I have a full set of LT1 injectors available,...

I have a full set of LT1 injectors available, includes the rails. $250 shipped, PM me if interested.
04-08-2019, 09:49 PM
Replies: 15
Views: 1,005
Posted By FYREANT

Iíd go as far to say - nope. Not even a little.....

Iíd go as far to say - nope. Not even a little.. :hide:
04-08-2019, 06:46 PM
Replies: 65
Views: 8,801
Posted By FYREANT

why are you trying to run the engine on the...

why are you trying to run the engine on the stand? I wouldnít do that personally. Sort of a waste of time (and now a waste of money) if you ask me.
04-05-2019, 02:01 PM
Replies: 6
Views: 715
Posted By FYREANT

I have a triple. I wish them luck...

I have a triple.



I wish them luck Mark.. lol. The triple is big and fills most the bellhousing. When I had the torque tube off and was looking at the bellhousing and clutch I was worried I...
04-05-2019, 07:26 AM
Replies: 6
Views: 715
Posted By FYREANT

Sounds like you already have a plan then! :cheers:

Sounds like you already have a plan then! :cheers:
04-04-2019, 09:06 PM
Replies: 2
Views: 230
Posted By FYREANT

Correct. Wonít work. Need the actual LT specific...

Correct. Wonít work. Need the actual LT specific one. Bluegrass Performance sells one. I have it, works great.
04-04-2019, 09:02 PM
Replies: 6
Views: 715
Posted By FYREANT

I do all my own work so I can chime in. First,...

I do all my own work so I can chime in. First, the Mantic is the best out there. Its a little more expensive, but it feels stock and holds great and has great road manners. I would recommend pulling...
Showing results 1 to 25 of 484
 


 
Forum Jump

Contact Us - About Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.