I’ve been including the Hi-4 Relay harness with all of my Light cannon and Stealth light cannon headlight kits. Now you have the opportunity to own one the simplest, and least expensive ways of increasing your headlight output.

The Radioflyer Hi-4 Harness is a Simple relay circuit that allows your low beams to remain on with your high beams. On dark roads, this more than doubles your light output without having to install expensive and often inferior aftermarket bulbs.

The Radioflyer Hi-4 harness installs in the under-hood fuse panel area. All you need to install them is a 10mm and ½” socket wrench. (a 3” extension is recommended) Installation takes less than 5 minutes and is completely reversible with no permanent modifications. The relay setup uses both a main fuse and your existing headlight fuses for double protection.

The Radioflyer Hi-4 harness is compatible with all current C5 headlight setups including most HID setups. (EXCEPT the Euro T84 headlights as these use a single bulb setup)

This modification is designed specifically for rural highway driving or poorly-lit road use. Remember that your high beams may cause glare to oncoming traffic so be mindful of other drivers.


This GP will last until Sunday May 23. The GP price is $25 shipped to the 48 states. International shipping is offered on an as-requested basis. The GP will end on Sunday Apr 25. Build time will begin at the end of the GP and will take about 1-2 weeks to get all the parts, pack and ship the kits.

I'm also offering the "6-pack" version which will allow the foglights to remain on with the high beams as well. If you want this modificaion, please include an additional $10.

I accept paypal or check/money order. Local pickups are welcome as well.

To get in on the GP, Please send an email to me (radioflyer97@gmail.com) with the following information:

Name:
Shipping address:
CF screen name:
Parts being purchased:
How you are paying: (paypal check etc)

 

Email sent.

 

 

email sent

 

are there any overheating issues? how long can you leave these on?

 

emal sent!

 

Pay pal previously sent to include the fog lights. Don't know if I managed to get in at the last minute for GP1 or this present GP2. Thanks again George.

 

You're good. Since you wanted thee foglight mod, i put you in on the GPII (didn't have enough relays to do the fog mod relays for everyone who wanted it) Apologies for the delay, I will have them out ASAP.

 

email sent

 

Radio Flyer, any comment to above?

thanks

 

email (order) sent. correct pp address requested to get you payment.

 

bump

 

Payment sent via paypal.

Russell

 

Order sent and I also need the correct PayPal address
Thanks
Bob

 

last Call. GP will end tonight at midnight

 

Paypal sent

 

Received my kit today but alas there were no instructions. The install may be intuitive for some folks but not for this guy!

 

installation:

There are 4 terminals on the relay.

#30 = orange fused wire
This goes to the battery terminal on the fusebox (1/2" nut)

(the color on the following wires may vary)

#85 = Black Ground wire
This goes to the 10mm nut behind the battery as a ground

#86 = Green trigger wire
This taps into one of the high beam fuses

#87 = Brown output wires
This taps into BOTH of the low beam fuses







For you guys with the 6-pack version, there's a blue wire that comes off the second relay that goes into your foglight fuse.

 

Update: All orders paid for before May 20 have been shipped. Remaining orders are waiting on additional parts.

 

Thanks for the install instructions and your email reply. Once I saw the pics, I realized I'd seen them before, just couldn't locate them.

Again, thanks for your reply.