When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
2003 z06 harnesses, lids, switches, PCM, ECM, TAC and more
going stand alone,. Took all of this off all prices OBO plus shipping
passenger complete Fuse box $75
engine bay fuse box $85
each of lids $5 with box purchase
PCM Tuned for highoctane and VATS cleared $450
TAC with wire harness $250
BCM $175
Main ENgine COMPlete Wire harness $375
Body control dash wires ALL chopped up $150 MAKE OFFER
Clutch pedal release starter ignition $25
FUlly complete and functioning Passenger door harness $95
Driver side door harness Cut at regulator connector $75
trunk switch $25
passenger door switch Cracked $25
Driver side PERFECT with memory $85
passenger regular and motor $75
passenger window glass with 30% tint $150
rear glass with de-fogger $350
I have ALL esle from this car OFF the car in other Threads SO JUST ASK I have it off the car... all left is frame and most figerglass so all Else up for grabs....
Front headlights & front Turn signals harness available?
yes I do and I believe the turn signals are samlll stand alon and the headlights i think its part of a front end wire harness.. Ill check later when get home... but I do have them boxed up
LOL
if you have the harness for the headlights/turn signals in a good condition, No cuts I'll need them shipped to NY 11413
Yes I believe front end wire harness is separate from the engine harness
LOL
if you have the harness for the headlights/turn signals in a good condition, No cuts I'll need them shipped to NY 11413
Yes I believe front end wire harness is separate from the engine harness
Looks like it but I can't tell for sure from the pic can you make sure if it's the harness connected to the headlights and turn signals?
How much shipped to NY 11413?
pulled it down and took close up what I recall connect to headlights ... just want to make sure this is what you need GOes to all other stuff like abs and washer fluid etc..
Designer Imagines A Corvette That Looks More Like a Corvette Than the Corvette
Slideshow: A Jaguar designer's personal project imagines what a modern front-engined Corvette might look like if Chevrolet revisited the golden age of the Stingray.
2003 z06 harnesses, lids, switches, PCM, ECM, TAC and more
