When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
ive just removed my front splitter as and got a new one.
Problem is as I removed it I noticed it was fixed high up on the front bumper, is this right?
i ask as I could easily go lower where there is a lip already on the bumper. This would lower the splitter but also seems neater as the top of the splitter sits against the lip on the bumper. The splitter on the side would also be fixed to the harder plastic section of the bumper as oppose to the soft fibreglass up top.
Last edited by SteveSierra; Nov 29, 2017 at 01:06 PM.
Thanks that’s what I thought. I guess I can either install the new one high where the old one was or get all the holes repaired and install it properly
I guess the previous owner put the sides high up for more clearance. Didn’t notice anything strange until I removed it, looked perfectly normal but with the correct position it will be at least 3 inches closer to the ground.
I am getting ready to install one on my base made for my base like welker1 and EVRose. Do I need to remove the side end air dam and leave the center piece there? Just quickly holding it in place I don't believe it will fit correctly unless I remove the side sections of the air dam. Thanks for any help didn't come with instructions.
I am getting ready to install one on my base made for my base like welker1 and EVRose. Do I need to remove the side end air dam and leave the center piece there? Just quickly holding it in place I don't believe it will fit correctly unless I remove the side sections of the air dam. Thanks for any help didn't come with instructions.
Yes, my side pieces are removed, I left the center piece.
Thanks guys a bunch with everything posted I could not find a positive post saying to remove them. I tried looking at pictures but it wasn’t clear as some looked like they were still on. Installing tonight. Already installed the ZR1 side skirts last year.
How does the zr1 splitter fit on a base?
