ckchan10

Hey guys, I'm replacing the oil pressure sender (behind the intake manifold) in an LS3 and wondering if anyone can confirm what I should torque the sender to. I've read a bunch of people say 15 ft-lbs and some say 26 ft-lbs. Can anyone please confirm the correct torque setting? Thanks!

Cherokee Nation

Snug it down..Three finger torque.

SteveDoten

Enough to seat the washer on ops.

I'd go with 150 inch pounds and call it a day.

HK770

From 11 G.M. manual: (sorry for being upside down)......Luck

If hard to read. ...26 ft # is. Answer

ckchan10

Thanks to everyone who answered!! I think I'll go with the manual suggestion since it's "official". This forum rocks!!