Jacking up C7 to swap tires/work on car
#1
Advanced
Thread Starter
Jacking up C7 to swap tires/work on car
What's the best place to jack up a C7 Z06?
I'm interested in jacking up the back to swap the rear wheels.
In the front I'm wanting to jack it up to swap splitters.
Any recommendations on jacks to use and placement?
I'm interested in jacking up the back to swap the rear wheels.
In the front I'm wanting to jack it up to swap splitters.
Any recommendations on jacks to use and placement?
#2
See the linked thread below. It doesn't start out as a pretty story, but there are a lot of good lessons and info therein.
https://www.corvetteforum.com/forums...k-failure.html
https://www.corvetteforum.com/forums...k-failure.html
#3
E-Ray, 3LZ, ZER, LIFT
Member Since: Sep 2007
Location: NE South Carolina
Posts: 29,447
Received 9,605 Likes
on
6,618 Posts
http://netwelding.com/Jacking_A_C7.pdf
It includes pics from the 2014 and more recent 4 volume 2016 Service Manual that show preferred jacking points.
It shows various jack pads and jack information.
Most important it includes precautions of being careful to avoid problems.
PS: This is a pic/text PDF of my install of a Splitter Protector that may be of interest:
http://netwelding.com/Splitter_Protectors.pdf
You’ll see I did jack up the car and used jack stands. Lifted somewhat higher than needed to help taking pics!
Last edited by JerryU; 02-25-2018 at 07:54 AM.
#11
Le Mans Master
... or you could just pick up a set: