thatsnapchatyellowc6

Hey guys, new to the forum I have an 09 velocity yellow corvette! I am shooting for the 10s!!! Juat looking for some feedback or advice to if anyone else has hit 10s with roughly the same mods as myself! Side note- I do plan to get a McLeod twin disc clutch and drag slick setup before July 7th (streetcar takeover Charlotte) where I intend to get my 10sec pass!

as of right now I have the following mods:
-stage 3 tick polluter cam
-long tube headers
-x-pipe
-2 step
-tune

Turbo6TA

Your going to kill yourself in that car !

jaredtxrx

Slicks, and not folding the car around a tree driving like a dumbshit on the street.

LMB-Z

510 rwhp from an LS3 with just a cam and headers??? I don't think so. I'd like to see the dyno chart on that one. I call BS. I don't think you are even close to 10's.

thatsnapchatyellowc6

EviLS7

You car can have all the horsepower it wants, but if it cant put it to the ground then its pointless. What kind of tires are you running? And how good are you at shifting?

thatsnapchatyellowc6

right now hankook ventus v12 evo (285/35/19) but when I go to the quarter I will have slicks... And not to be cocky but I can shift pretty decent

EviLS7

I only see one way to solve this... gotta run it at the strip and see how she does.

thatsnapchatyellowc6

agreed

windyC6

LOL....let us not forget that this is Corvette Forum....where anything is possible. Saw one post a while back where the guy/gal said that they could get any stock C-6 into the 10's simply because they were so good at hole shots.... Saw another one once where the guy/gal suggested that a typical stock C-6 should reach 200 MPH in about 17 seconds..... again. Isn't technology wonderful !!!!.....

thatsnapchatyellowc6

lmfao🤣🤣🤣🤣 you right

mikeCsix

OP, talk to HOXXOH, he's done it with his car for reasonable cost.

whiteboy

I am thinking mid 11 s with your set up. 10 s are probably going
to require another 150 HP. Good Luck

thatsnapchatyellowc6

thanks for the input!!!

mellojoe

liking this here: https://www.corvetteforum.com/forums...t-be-done.html

user lazerlemonta has done it

irok

car easily has enough power to run in the 10's

thatsnapchatyellowc6

that's what I was thinking! I have seen them time after time on YouTube hit 10s with a good clutch and drag slicks at my power level or even less

919cw313

Supercharge it.

thatsnapchatyellowc6

I plan to by the end of the year! But n/a 10 sec pass is the goal by July

HOXXOH

According to my experience, your 2009 Vette is going to need a minimum of a 1.6 60' and a 7.0 at the 1/8 to run a 10 anything unless you have a ton of back half power. The 1/8 timeslip shows power in the lower 400 range, but nowhere near the 514 shown on the dyno sheet for whoever owns that 2008 Vette.

My opinion is that you either can't drive well enough or the 514 hp on the dyno sheet is wishful thinking. Maybe both.