FS: ***F/S BRAND NEW Forged LT1 Short Block*** $4399
#1
Advanced
Thread Starter
***F/S BRAND NEW Forged LT1 Short Block*** $4399
Re-posting this as the original thread was getting long....I only have 1 left.
I have for sale a BRAND NEW FORGED Gen V LT1 Short block for sale. This would be a perfect upgrade or replacement for a high horsepower boosted or N/A setup. This is the best deal on a new forged bottom end that you will find. The short block includes:
- brand new GM LT1 Engine Block (no core required)
- Stock Crankshaft (with EITHER dry sump or wet sump crank)
- Manley H-Beam Rods
- Manley 2618 Pistons (either 10.5:1 OR 11.7:1 compression, I have both
pistons still available)
- ARP Rod Bolts
- Premium Total Seal Rings
- Clevite Bearings
- Professionally Balanced (please allow a few days for balancing as it will be different depending on piston selected)
Price is $4399 plus shipping...PM if interested...
I have for sale a BRAND NEW FORGED Gen V LT1 Short block for sale. This would be a perfect upgrade or replacement for a high horsepower boosted or N/A setup. This is the best deal on a new forged bottom end that you will find. The short block includes:
- brand new GM LT1 Engine Block (no core required)
- Stock Crankshaft (with EITHER dry sump or wet sump crank)
- Manley H-Beam Rods
- Manley 2618 Pistons (either 10.5:1 OR 11.7:1 compression, I have both
pistons still available)
- ARP Rod Bolts
- Premium Total Seal Rings
- Clevite Bearings
- Professionally Balanced (please allow a few days for balancing as it will be different depending on piston selected)
Price is $4399 plus shipping...PM if interested...
#4
Scientific Negotiator
Member Since: Jul 2005
Location: USA
Posts: 6,398
Received 1,836 Likes
on
1,018 Posts
St. Jude Donor '07-'08-'10, '14
Wow, NICE
#6
Advanced
Thread Starter
If you are looking for 1000+ horsepower, this particular short block is probably not for you. On the safe side, this will be good for 800-850 assuming you have the appropriate power adders...The rods and pistons are good to about 1000, but I personally have not run the stock crank over 800...
The following users liked this post:
FYREANT (05-03-2018)