IW 18% supporting mods
#1
4th Gear
Thread Starter
IW 18% supporting mods
Newbie to the forum here with a '15 ZO6 and I am wondering if I can get some suggestions on any other supporting mods for the IW 18% crank pulley. Eventually, I am hoping for whipple to roll out with their 2.9 without having to cut up the wiper cowl, but for now this is what I have. Any suggestions would be appreciated.
-upgraded Heat Exchanger
-intercooler expansion tank
-160 degree thermostat
-Prospeed dual electric fans
-Mamo ported throttle body
-Kooks 2" primary headers
-Kooks x-pipe
-AFE Intake
-Heat shield on oil line sleeve
-upgraded Heat Exchanger
-intercooler expansion tank
-160 degree thermostat
-Prospeed dual electric fans
-Mamo ported throttle body
-Kooks 2" primary headers
-Kooks x-pipe
-AFE Intake
-Heat shield on oil line sleeve
#3
4th Gear
Thread Starter
Thanks! Luckily, the kooks LT's are ceramic coated. I spoke with Joe@CPR yesterday and he recommended meth injection as well. Going to try that out. I'm hoping to pick up some 19x12 replica's with some big meats in the near future. Thanks again!