FS: Fiberglass Rear Spring - Out of body off 1972 LT1
#1
Racer
Thread Starter
Fiberglass Rear Spring - Out of body off 1972 LT1
I am selling a fiberglass rear spring which came out of a 1972 LT1 for $125 OBO plus shipping from 10598. We took it out because the owner of the car is slowly but surely bringing the car back to stock. This spring was put in by the PO during the body off restoration ~2013 and has less than 3,000 miles on it.
Last edited by ThumpingLotus7; 08-19-2018 at 02:01 PM.
#5
Drifting
Member Since: Aug 2016
Location: CLEVELAND STUCK IN OHIO
Posts: 1,763
Received 772 Likes
on
498 Posts
I have a intrest in spring,, but , looking at pg, 166 and not finding a 330# listed,, ( using your image, , just 315#, 340#, and 355#, ) part numbers listed not the same, I'm just trying to pin down exactly what you have,, ,, ,, thoughts? thanks
#6
Racer
Thread Starter
Its either a 315 or 340 I'm not sure since I didn't put it in the car only took it out. But it is definately a small block spring. Sorry about the confusion, was looking at the wrong catalog before. If you know how to tell I can apply your knowledge.
#7
Burning Brakes
I believe that is a 340lb spring. The spring rates correspond to 101 = 315, 103 = 340, 105 = 360 (i think). Looks like the 103 on the sticker is punched, which seems to indicate a 340. Just my .02. Hope that helps.
Bryan
Bryan
The following users liked this post:
ThumpingLotus7 (07-30-2018)
#11
Racer
Thread Starter
A quick back of the envelop calculation yields a shipping cost of $450 - $1000 depending upon package sizing and weight. I am not willing to do this, there is way too much risk if I estimate wrong, or you don't like the spring etc etc.