FS: Used Morimoto LED headlights for C6
#1
Used Morimoto LED headlights for C6
Good evening everyone,
I am selling my Morimoto LED headlights for the C6 Corvette, I have only had them installed for about 3 weeks but have found another car that I want, so my loss is your gain.
I purchased these headlights from a forum vendor, Vette Lights, a few weeks ago and had them professionally installed and uninstalled at a local shop here. They are full LED including the turn signals, "L" light and the primary beam. These headlights look absolutely amazing day or night, and in my opinion, really help make the C6 look much more modern. In regards to light output, there is a single primary beam headlight that is LED, as opposed to the dual bulb HID/incandescent setup in the factory unit, and the Morimoto is on par with the low beam factory unit, while the high beam, in my opinion, is much brighter. The LED turn signal can be wired to be either fully on/off when the signal is in operation, or sequential, meaning the individual bulbs light up one at a time from the bottom to the top.
I am looking to get $850.00 shipped OBO, which is a significant savings for headlights that are in perfect shape.
I can't think of anything else to say, if anyone has any questions please feel free to PM me or ask in the thread, and thank you for your time. to the top, it is a simple as plugging a male and female connector into the headlights.
I am selling my Morimoto LED headlights for the C6 Corvette, I have only had them installed for about 3 weeks but have found another car that I want, so my loss is your gain.
I purchased these headlights from a forum vendor, Vette Lights, a few weeks ago and had them professionally installed and uninstalled at a local shop here. They are full LED including the turn signals, "L" light and the primary beam. These headlights look absolutely amazing day or night, and in my opinion, really help make the C6 look much more modern. In regards to light output, there is a single primary beam headlight that is LED, as opposed to the dual bulb HID/incandescent setup in the factory unit, and the Morimoto is on par with the low beam factory unit, while the high beam, in my opinion, is much brighter. The LED turn signal can be wired to be either fully on/off when the signal is in operation, or sequential, meaning the individual bulbs light up one at a time from the bottom to the top.
I am looking to get $850.00 shipped OBO, which is a significant savings for headlights that are in perfect shape.
I can't think of anything else to say, if anyone has any questions please feel free to PM me or ask in the thread, and thank you for your time. to the top, it is a simple as plugging a male and female connector into the headlights.
Last edited by Alanlogsdon87; 08-22-2018 at 09:09 PM.
#8
I know it always happens to me. I will de diligent for a while and check them couple times a day and then I get busy and don’t for a couple of days and I always just miss out on stuff.
The following users liked this post:
1Willy1 (02-05-2021)
#13
Instructor
#14
Burning Brakes
The format of this site on my phone makes it easy to go from one thread down into another “related” thread without realizing it and you might have done that as there is no post like that in this thread.