FS: 2007 Z06, everything under the hood





1, 2008 LS7 Long block with cracked block, $ 2,450.00
2. Intake with throttle body and fuel rail 550.00
3. 8 coils with 1 coil bracket and 8 plug wires 200.00
4. Radiator with fan and controller complete 375.00
5. A/C Condenser 100.00
6. Oil cooler hoses from block to cooler 125.00
7. Unknown hose assembly 50.00
8. Power steering pump, pully, reservoir, lines 250.00
9. ABS controller and bracket, needs work 150.00
10. Exhaust manifolds, cats and O2 sensors 750.00
11.Oil tank with hoses to engine 450.00
12.Water pump, pullies, starter, brackets 350.00
13. Engine wire harness complete 250.00
14. ECM W/brackets, will need programing 110.00
Crack is in the rear cly. block not the sleeve. Out of our 2008 Z06, overheated at the track. Heads have had the updating done to them.
They look complete I have gaskets too but suggest new.
Oil cooler lines
I have no idea what these hoses are! Each end takes clamps not fittings so they must be low pressure what ever.
Corrosion where the lines screw in. It probable needs to be completely rebuilt.
I have no idea if the starter works but did when it was wrecked.
Missing the bracket that hold one set of coils
I think the map senor plug is cut off will need a pig tail installed.





The Best of Corvette for Corvette Enthusiasts









