When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I have a LOT of aluminum half shafts to sell. I switched to a 9" Ford rear axle years ago and will never use these. Some have useable u-joints and some have the reason I went straight axle still in them. $60 shipped to anywhere that USPS will take them and not add extra fees or customs declarations.
I am unaware of any differences in half shafts between the D36/D44 diffs and between the years. All C4 half shafts take the same 1350 U-joints. I can take center to center measurements if you are in need of a replacement or interested in keeping a spare on hand. I have a 9" Ford live axle under my car and do not have any use for these. I accumulated them over the years by buying complete rear suspensions to harvest the differentials contained within. I also have an inventory of inner/outer axles, hubs, knuckles, toe rods, ARP long studs, camber rods, brackets, spring mounting parts, etc.
Are these good for both Dana 36 and Dana 44? Are they for 86 to 89 or a 91?
All C4 half shafts are interchangeable regardless of differential & model year. Only difference is tube wall thickness, with early models being slightly thinner.
Last edited by TylerScott; Jun 10, 2026 at 04:14 PM.
All C4 half shafts are interchangeable regardless of differential & model year. Only difference is tube wall thickness, with early models being slightly thinner.
Thank you very much Mr Scott. I seem to have forgotten so much information such as this. The thinner ones are from 84 and 85? or into 86 and later? Thank you again.
Designer Imagines A Corvette That Looks More Like a Corvette Than the Corvette
Slideshow: A Jaguar designer's personal project imagines what a modern front-engined Corvette might look like if Chevrolet revisited the golden age of the Stingray.
Half Shafts
