Need Help in Chapel Hill, NC
#1
Drifting
Thread Starter
Need Help in Chapel Hill, NC
Any member out there willing to help me install a ported throttle body? I thought I could handle it after watching the YouTube video but this looks way more complicated. One of the bolts looks nigh impossible to reach and I'm leery of those 2 tubes leading into the intake.
Much appreciated.
Much appreciated.
#2
Drifting
If I were closer I could swing by and help ya out with it, I'm in eastern NC. Those hoses in the intake are just vent hoses. you aren't going to damage them. Looks like a Vararam intake on the car. Did you install that yourself? If so, its far more challenging to do. I still have the stock intake but dropped it and swapped out to a ported thottle body in about 15-20 minutes max from start to finish on my '16. Just pull the 4 bolts, unplug it, plug new one in, make sure gasket is still in the groove on the intake side and install and tighten the bolts back down.