My First G-Code/CNC
Thread Starter
Le Mans Master
Joined: Oct 2000
Posts: 8,897
Likes: 1,357
From: Santa Ana CA
My First G-Code/CNC
This shows a billet aluminum spacer that I devised for an alternator bracket that I invented. I have a guy turn these out for me on a Fadal 4020.
The photos also show one that I did out of a 2"x4" on my ShopMaster that I programmed using the G-simple software with the G-code slightly modified in Notepad.
Takes him about 12 minutes to make one and takes me about 10 times that long and I didn't even add the slots and hole.
The photos also show one that I did out of a 2"x4" on my ShopMaster that I programmed using the G-simple software with the G-code slightly modified in Notepad.
Takes him about 12 minutes to make one and takes me about 10 times that long and I didn't even add the slots and hole.
