Anyone know a good shop in Dallas area that does aftermarket front splitter, side, and spoilers installation for a reasonable prices for the C7? Thanks

Check the right side of this page.....CF Vendors are listed. You have two very good people in the DFW area to go to; 21MC, talk to John Page or LG Motorsports, ask for Anthony

Just out of curiosity, is there a reason why you don't want to tackle the install job yourself? It's a wiz-bang EZ install; might take 30 minutes to an hour for all three items.....pending using a lift or jack stands.

I might try to install it with some help but I want to see how much the professional charge.

Thanks! I will check with them.

You could check with Corvette World.

Thanks! I will check all of them out and compare prices and work they do.

Call 21st Century Muscle Cars... Matt... Located just north of Beltline on Midway. Tremendous work on Vettes... Have done a ton of engine modifications on mine and I am scheduled in to do the very work you asked about in two weeks.

If you are in the Addison, TX area, 21st Century is right on Midway by the airport. They have done work on several of my Corvettes. Never an issue.

Just sent you a p m

I've had LG Motorsports in Plano work on my Z06 and it's an eight hundred round trip drive for me, but well worth it to have a shop that knows Corvettes, work on my car.

What side of the Metro-Plex do you live on.....perhaps a member of LSCC or would like to join....PM me, Mike

I live in Arlington but don't mind driving around to find a good place.

Our splitter and side skirts are pretty easy to do. The front goes on with hardware already in the nose so it is pretty much a bolt on piece.


The rockers use four bolts already there and you have to drill for 3 rivets per side. Takes a little time to line them up, drill, remove, clean, then install but not long.

Customer did a killer write up on the side skirt install


http://netwelding.com/Side_Skirts.pdf

I have both pieces in stock, can ship, you can pick up, or we can install them for you. Let me know if you have any questions.

Call Dave at DMS Corvette on Sheppard St near Forest and Plano Road in Garland.

LG would get my vote.

Also Carr's Corvettes & Customs over in Plano.

They installed my lowering bolts.

I did all of mine in CF and I am 79 years old, try it you will enjoy doing this yourself

I just used them for my LS9 engine project...see my thread in the ZR1 section discussing cylinder head/valve-train replacement.