FS: Speed Direct Rod Links Clutch Linkage 1963-1967 Corvette
Thread Starter
Drifting
Joined: Nov 2016
Posts: 1,581
Likes: 559
From: LA-LOWER ALABAMA
Limp,
My (not very old) Mcleod Street clutch setup had no adujstment left but after I put in a TKX and another Mcleod Street clutch I had plenty of adjustment therefore really did not need this setup. Hard to believe that both setups used the identical pressure plate and had that much of a difference in finger height. Same flywheel,same bellhousing, identical throwout bearing, same clutch fork. Just a difference in pressure plates. Figure I probably will never use this setup. I am using the OEM linkage.
My (not very old) Mcleod Street clutch setup had no adujstment left but after I put in a TKX and another Mcleod Street clutch I had plenty of adjustment therefore really did not need this setup. Hard to believe that both setups used the identical pressure plate and had that much of a difference in finger height. Same flywheel,same bellhousing, identical throwout bearing, same clutch fork. Just a difference in pressure plates. Figure I probably will never use this setup. I am using the OEM linkage.
Drifting
Joined: Sep 2024
Posts: 1,630
Likes: 1,067
From: Florida
Limp,
My (not very old) Mcleod Street clutch setup had no adujstment left but after I put in a TKX and another Mcleod Street clutch I had plenty of adjustment therefore really did not need this setup. Hard to believe that both setups used the identical pressure plate and had that much of a difference in finger height. Same flywheel,same bellhousing, identical throwout bearing, same clutch fork. Just a difference in pressure plates. Figure I probably will never use this setup. I am using the OEM linkage.
My (not very old) Mcleod Street clutch setup had no adujstment left but after I put in a TKX and another Mcleod Street clutch I had plenty of adjustment therefore really did not need this setup. Hard to believe that both setups used the identical pressure plate and had that much of a difference in finger height. Same flywheel,same bellhousing, identical throwout bearing, same clutch fork. Just a difference in pressure plates. Figure I probably will never use this setup. I am using the OEM linkage.
