F/S: Elemental Designs Components PLUS tweeters in the 'A' pillars
#1
Tech Contributor
Thread Starter
F/S: Elemental Designs Components PLUS tweeters in the 'A' pillars
I bought these a while back with the intention of installing them in my Corvette when I upgraded the audio system. Then I decided to go with Focal 165KR from Dennis.
These are Elemental Designs Edi e3.65i components.
These have never been installed or used. They have been in a box for months.
I decided it was time to try to sell them. ALL READY FOR YOU TO INSTALL.
I'll start out asking $300 (+ shipping) for everything, including the 'A' pillars with the tweeters already installed (mounting cost me $200) and nice speaker plates (a $40 value).
These have been SOLD! Thanks Frank.
Please note there is some minor stretching of the vinyl on the part of the 'A' pillars nearest the windshield. Probably not even noticeable once you install them. Check out the photo #7.
Here are some photos.
These are Elemental Designs Edi e3.65i components.
These have never been installed or used. They have been in a box for months.
I decided it was time to try to sell them. ALL READY FOR YOU TO INSTALL.
I'll start out asking $300 (+ shipping) for everything, including the 'A' pillars with the tweeters already installed (mounting cost me $200) and nice speaker plates (a $40 value).
These have been SOLD! Thanks Frank.
Please note there is some minor stretching of the vinyl on the part of the 'A' pillars nearest the windshield. Probably not even noticeable once you install them. Check out the photo #7.
Here are some photos.
Last edited by ncvette_1FUNRIDE; 08-01-2012 at 08:35 PM.
#3
Tech Contributor
Thread Starter
#5
Melting Slicks
You should def split them out (especially if someone asked???) as not everyone wants a-pillar tweets, but most anyone would want those other pieces, just saying ...
#6
Tech Contributor
Thread Starter
I didn't think about talking the tweeters out and selling the 'A' pillars separate from the components.
The 'A' pillars were 'fabbed' for these particular tweeters.
I guess if someone wants just the 'A' pillars, I can try to take the tweeters out.
Then I could sell the components separately.
I would need to get $200 for the 'A' pillars and $100 for the EDI components.