Inside Pratt & Miller photos
#1
Team Owner
Thread Starter
Member Since: Sep 2003
Location: Raleigh / Rolesville NC
Posts: 43,084
Likes: 0
Received 25 Likes
on
25 Posts
Inside Pratt & Miller photos
have a look guys
Originally posted by Jason of Katech over on LS1 tech
http://ls1tech.com/forums/showthread.php?t=575722
Originally posted by Jason of Katech over on LS1 tech
http://ls1tech.com/forums/showthread.php?t=575722
#3
Burning Brakes
Member Since: Feb 2003
Location: Bristol Ct
Posts: 1,016
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by AU N EGL
have a look guys
Originally posted by Jason of Katech over on LS1 tech
http://ls1tech.com/forums/showthread.php?t=575722
Originally posted by Jason of Katech over on LS1 tech
http://ls1tech.com/forums/showthread.php?t=575722
#8
Former Vendor
Member Since: Dec 2004
Location: Wixom Michigan
Posts: 220
Likes: 0
Received 0 Likes
on
0 Posts
If you look closely you will see two buildings. They just built the second one (addition) a couple years ago, and the main building several years prior. Before that they were in a little ho-hum strip-shop. They are only a few miles away from us. That place is huge and immaculate. You could eat off their shop floor. I think most of their work is for GM Racing, like an extended GM division without the red tape. We've bought some parts from them but it is like pulling teeth since GM keeps them so busy. The quality of their work is unbelievable. Incredible amount of cash going into that place.
Bob
Bob
#11
Race Director
Member Since: May 2000
Location: No more yankee my wankee, the Donger is tired!
Posts: 17,101
Likes: 0
Received 1 Like
on
1 Post
Originally Posted by AU N EGL
have a look guys
Originally posted by Jason of Katech over on LS1 tech
http://ls1tech.com/forums/showthread.php?t=575722
Originally posted by Jason of Katech over on LS1 tech
http://ls1tech.com/forums/showthread.php?t=575722
And posted by you not to long ago either
http://forums.corvetteforum.com/show....php?t=1499468