Question on race seat (evo or others).
02-24-2008, 02:55 PM
#1
Drifting
Thread Starter
Question on race seat (evo or others).
Anyone who has intalled the sparco evo seat on a C6Z, do you guys get enough clearance head room with your helmet?
I'm asking because I recently attempted to install an OMP race seat but took it out because I could not fit with my helmet on. BTW, when I installed the seat, I installed with the slider which added to the heigth of the seat. I'm 5'10" tall just for you FYI. Finally, how did you guys cope with the seatbelt buckle? Did you remove it from the stock seat & transfer it on the new (race) seat? Suggestions are appreciated! TIA
I'm asking because I recently attempted to install an OMP race seat but took it out because I could not fit with my helmet on. BTW, when I installed the seat, I installed with the slider which added to the heigth of the seat. I'm 5'10" tall just for you FYI. Finally, how did you guys cope with the seatbelt buckle? Did you remove it from the stock seat & transfer it on the new (race) seat? Suggestions are appreciated! TIA
02-24-2008, 05:09 PM
#2
Team Owner
Member Since: Sep 2003
Location: Raleigh / Rolesville NC
Posts: 43,084
Likes: 0
Received 25 Likes
on
25 Posts
No slider, use a fixed set of rails and the bottom of the seat is almost on the floor.
Some guys once they have there Race seat set, then just swap them back and forth
Some guys once they have there Race seat set, then just swap them back and forth