bolt inside the master cylinder?
#1
Melting Slicks
Thread Starter
bolt inside the master cylinder?
Got 90% of my new brake swap done...
Noticed in my old master, in the front resevoir there is a small bolt in a port... But in the new master it is not there!
Am I supposed to be taking that out & putting it in the new one, or is it unneeded??
Thanks in advance... Chris
Old
New
Noticed in my old master, in the front resevoir there is a small bolt in a port... But in the new master it is not there!
Am I supposed to be taking that out & putting it in the new one, or is it unneeded??
Thanks in advance... Chris
Old
New
Last edited by CDaniel525; 03-18-2010 at 12:28 PM. Reason: add pics
#2
Team Owner
Member Since: Sep 2006
Location: Westminster Maryland
Posts: 30,173
Likes: 0
Received 2,878 Likes
on
2,515 Posts
Hi Chris,
Yes it needs to go back in the master cylinder.
You put it in after the piston is in place. The pin acts as a forward and backward 'stop', acting on the secondary (front) piston.
Regards,
Alan
Yes it needs to go back in the master cylinder.
You put it in after the piston is in place. The pin acts as a forward and backward 'stop', acting on the secondary (front) piston.
Regards,
Alan
#3
Le Mans Master
Gary