ABS pump cover
#1
Racer
Thread Starter
ABS pump cover
In the 1990-1991 Corvette Technical Information Manual & Judging Guide on page 58 paragraph 5 it mention a vinyl covered flexible pad, in the rear storage compartment behind the drive seat under the plastic tray, that covers the ABS system.
Does anyone have such a item and if so could you post a picture of what this pad looks like? I've searched everywhere and can't even come up with a part number.
Thanks
Ken
Does anyone have such a item and if so could you post a picture of what this pad looks like? I've searched everywhere and can't even come up with a part number.
Thanks
Ken
#3
Racer
In the 1990-1991 Corvette Technical Information Manual & Judging Guide on page 58 paragraph 5 it mention a vinyl covered flexible pad, in the rear storage compartment behind the drive seat under the plastic tray, that covers the ABS system.
Does anyone have such a item and if so could you post a picture of what this pad looks like? I've searched everywhere and can't even come up with a part number.
Thanks
Ken
Does anyone have such a item and if so could you post a picture of what this pad looks like? I've searched everywhere and can't even come up with a part number.
Thanks
Ken
The following users liked this post:
kenpeindl (11-25-2015)
#4
Racer
Thread Starter
Looks like it to me. Not much of a cover is it. The book describes it as approximately 12"x14" X 1" inch thick. Doesn't look to hard to duplicate. I really appreciate you taking the time and posting these pics. I searched for days trying to find information. I'm going to bookmark this page for the future.
Thanks again
Ken
Thanks again
Ken
#5
Racer
No problem! It may have been 1" thick when the car was new 20+ years ago
I'm building a custom rear interior, so won't be reusing the foam pad. If you want it for a point of reference, it's your for the cost of shipping!
Happy Thanksgiving!
I'm building a custom rear interior, so won't be reusing the foam pad. If you want it for a point of reference, it's your for the cost of shipping!
Happy Thanksgiving!
#6
Racer
Thread Starter
Thank and Happy Thanksgiving to you.
Ken
Last edited by kenpeindl; 11-25-2015 at 09:26 PM.
#8
That is a incorrect mat for a 90-91 car. The correct one gets pushed down into the rear cavity and the plastic tray goes over it.
This is what is should look like.
This is what is should look like.
#10
Racer
Thread Starter
Yes that one look more like what's already on the side walls. Thanks for the pics chumpvetted and thanks Lonnie for the refund. I have gotten so much help information from this forum Over the past year it is truly the best. I posted on both the NCRS forum and FB page and got no replies. The funny thing is I couldn't find any listing for this piece in any GM parts book or service manual.
Thanks to both of you and Happy Thanksgiving.
Ken
Thanks to both of you and Happy Thanksgiving.
Ken
#11
The callout for the part is the rear compartment section. It is listed as a non service item. You only hope is to scour eBay or call the corvette salvage yards. Most were probably ripped out at some point in the service history and never replaced.