My FAST XFI 2.0
#1
Instructor
Thread Starter
My FAST XFI 2.0
My A/F target ratio is set to 15.86, and the actual A/F ratio is 15.86 at idle. How do I change this?
I looked into the online manual; and found the table I need to adjust; TARGET AIR/FUEL RATIO vs RPM and MAP. I can't find this table, on the C-COM software. BTW I am set to SPEED DENSITY.
So how do I find this table, are how do I reset the A/F ratio to idle the car richer.
I looked into the online manual; and found the table I need to adjust; TARGET AIR/FUEL RATIO vs RPM and MAP. I can't find this table, on the C-COM software. BTW I am set to SPEED DENSITY.
So how do I find this table, are how do I reset the A/F ratio to idle the car richer.
#3
Burning Brakes
Member Since: Jul 2009
Location: Ashland PA
Posts: 1,246
Received 91 Likes
on
79 Posts
2021 C4 of the Year - Modified Finalist
Did you try contacting FAST, or you could try here http://www.gearhead-efi.com/Fuel-Injection/forum.php
#4
Instructor
Thread Starter
Did you try contacting FAST, or you could try here http://www.gearhead-efi.com/Fuel-Injection/forum.php
Thanks for the gearhead web site, will give it a look.
#5
Safety Car
I have briefly seen the fast tables I believe it was based off the gen 7 dfi which I have. can you post photos of the table options you have? are you tning with a wideband? (assuming yes). On the Gen 7 dfi there is a table showing map vs VE, this is the fueling table. If I can see what youre looking at Id be happy to try and help if I can
#6
Safety Car
My A/F target ratio is set to 15.86, and the actual A/F ratio is 15.86 at idle. How do I change this?
I looked into the online manual; and found the table I need to adjust; TARGET AIR/FUEL RATIO vs RPM and MAP. I can't find this table, on the C-COM software. BTW I am set to SPEED DENSITY.
So how do I find this table, are how do I reset the A/F ratio to idle the car richer.
I looked into the online manual; and found the table I need to adjust; TARGET AIR/FUEL RATIO vs RPM and MAP. I can't find this table, on the C-COM software. BTW I am set to SPEED DENSITY.
So how do I find this table, are how do I reset the A/F ratio to idle the car richer.
#7
Instructor
Thread Starter
#8
Safety Car
Multiply all the numbers you see by 14.7 that will be your afr. When I will get home I will look up the location of the lamba to afr display change.
#9
Safety Car
Underneath the file tab there is a command for lambda mode, click that and it will show afr instead of lambda.
Last edited by bjankuski; 02-15-2016 at 06:33 AM.
#11
Instructor
Thread Starter
I bought mine from Dan White Racing, with his adapter that allowed me to plug into the stock harness.
Again a little dusty, showing the FAST XFI with the Dan White adaptor, and the Holly HSR.