Looking for some parts/installation advice...
#1
Intermediate
Thread Starter
Member Since: Apr 2014
Location: Phoenix AZ
Posts: 40
Likes: 0
Received 0 Likes
on
0 Posts
Looking for some parts/installation advice...
Hello All. I'm Changing to 113 heads on my 86E. What is the recommended gasket brand/thickness? (Flat top pistons.)
I've heard that 113's can be tricky to get sealed on a block that hasn't been decked. Any truth in that statement?
Thoughts on using Permatex Copper gasket spray on the head gaskets?
Keeping in mind that I have an SR intake, what intake gasket size should I get?
I've read that 86 700R4 has a 2025 rpm stall convertor. Would I be ok with an xfi268 cam (Listed on COMP website as needing 2000+ RPM stall)?
Thanks for looking,
E
I've heard that 113's can be tricky to get sealed on a block that hasn't been decked. Any truth in that statement?
Thoughts on using Permatex Copper gasket spray on the head gaskets?
Keeping in mind that I have an SR intake, what intake gasket size should I get?
I've read that 86 700R4 has a 2025 rpm stall convertor. Would I be ok with an xfi268 cam (Listed on COMP website as needing 2000+ RPM stall)?
Thanks for looking,
E
#2
Intermediate
Thread Starter
Member Since: Apr 2014
Location: Phoenix AZ
Posts: 40
Likes: 0
Received 0 Likes
on
0 Posts
Anybody??? Please.
You don't have to answer all my questions. Just asking for any knowledge on any of these questions.
I'm at the point where I have to pick the gasket sets. Any thoughts on the thickness at least?
Thanks again,
Eric
I'm at the point where I have to pick the gasket sets. Any thoughts on the thickness at least?
Thanks again,
Eric