IN DEBT

Would someone please post a Pic of their engine bay, I was wanting to see how clean this Kit (TTiX) looks. I'm in the process of going from a SC to a TT kit in the near future and I'm trying to make my mind up.

Thanks

mdhmi

IN DEBT

mdhmi,

Man, thanks that looks very clean, I just saved it to my pic's.

0todd@rpmtransmissions

How about underneath?

IN DEBT

Todd,

I've been lucky so far, knock on wood. I'll be giving you a call in the near future, you can bank on that.

0todd@rpmtransmissions

I actually meant I was looking for some pictures of the X kit from the bottom side.

IN DEBT

My Bad!

peter pan

I want to see some of those bottom shots to

0todd@rpmtransmissions

No problem. I can see why you thought I was talking about your drivetrain. The TTiX kit should come with our phone number on the outside of the box.

RoadRebel

It doesnt take long before you need to find it in a hurry after getting one though

Phil

This is not finish welded or coated.

BLOWNZO6

For those of you with ground clearance concerns.. the TTi kit has nothing that sits lower than the oil pan.



Here is a picture of my finished exhaust. I chose to use a Corsa X Pipe and fabricated the mid pipes from the X Kit DP's to the X pipe. This also shows the coated and finished parts.



I have A LOT more...

BLOWNZO6

The passenger side pipe will rub with whees that wide on them.. only at FULL lock to the left. The DR side pipes are not in a position to rub.

You can flatten the pipe on the passenger side to get around this. I have stock size tires on my Z and did not flatten the pipe, it is nothing to worry about and easy to work around either way.

1%r

BLOWNZO6

Hrmm... don't know how my post quoting yours ended up being above this one...

1%r

The forum has been all day.

1%r

See

FactoryRaceCar

Proof I am always a day late and a dollar short

FactoryRaceCar

Folks... I think I have had too much to drink...

BLOWNZO6

I remember this movie... GROUNDHOG DAY!!!

FactoryRaceCar

Nick can you post some underneath shots of the front cross member? I just need to see if the pipes will rub against 18X10 front wheels with 275/35/18 tires

Thanks!