letterisk

i know a friend who knows a welder and i was wondering how much would the labor be to install these e- cut-outs.?

http://www.doubledmods.com/DMH-LOW-P...air-dmhlp1.htm

lucky131969

Shouldn't you ask your friend, to ask the welder...for the quote?

letterisk

mhmmm i knowww but i was just wondering what would be reasonable since i have never had welding done to my car.

Sea Five

A local chain shop charged me 150 (cash) to cut and install 2 Y-Pipe manual exhaust cutouts. i wired the valves and bolted them up myself afterward.


.....Now I have a welder.

WKMCD

My guy welded them to the 3 inch X-pipe without even dropping the pipe. He welded the top from the inside.

.....Now, I don't have a welder.

Corvette Don

I had my welder do it for $30, he did not have to drop anything.

Bad97ta

the average shop will charge around 50 to 60 bucks to weld each one. they will not do any wiring. but if you know someone then im sure this is way to much to pay

letterisk

so how do they do the wiring for the switch to open and close the cut-outs?

Bad97ta

you need a positive and neg. same as a cig lighter. but they wont wire it. its a plug and play anyway to the cutout.

Starpegs

Just had DMH cutouts installed on my stainless x pipe. The muffler guy didnt want to do it MIG because of the stainless, so we marked the pipes and he removed the x pipe. I took it to a welding shop who specializes in TIG welding. They did an excellent job. Cost $75. I did all the wiring. Very happy with install.

4SFED Z

My guy charged 150 and wired. That's cause I'm special lol. 200 to do all otherwise

Bad97ta

what kinda special.......

Monkey D. Luffy

How much HP gains did you get with the cut outs?