SCM Code B2605 Caused Check Engine Light.
#1
Intermediate
Thread Starter
Member Since: May 2013
Location: Cincinnati Ohio
Posts: 27
Likes: 0
Received 0 Likes
on
0 Posts
SCM Code B2605 Caused Check Engine Light.
Hello All,
I have the 2000 Corvette and the Check Engine Light came on. I checked the code on the DIC (Key to On- Press and hold Option+ Fuel 4 times); the only code is B2605. Then after the DIC cycled through I tried resetting it by pressing and holding Reset; however, the DIC still shows 1 CODES. I cannot reset this to save my life and that CEL is really bothering me.
Also, can this code throw the CEL?
Please help.
-Thanks,
Ska
I have the 2000 Corvette and the Check Engine Light came on. I checked the code on the DIC (Key to On- Press and hold Option+ Fuel 4 times); the only code is B2605. Then after the DIC cycled through I tried resetting it by pressing and holding Reset; however, the DIC still shows 1 CODES. I cannot reset this to save my life and that CEL is really bothering me.
Also, can this code throw the CEL?
Please help.
-Thanks,
Ska
Last edited by aks8586; 10-23-2016 at 11:59 AM.
#2
Intermediate
Thread Starter
Member Since: May 2013
Location: Cincinnati Ohio
Posts: 27
Likes: 0
Received 0 Likes
on
0 Posts
B2605 is a "Seat Front Vertical Position Sensor Failure"
NO WAY that code can cause a CEL.
I suggest that you start and run the engine and pull codes with the engine running. To pull codes with the engine running you must use the RESET button to clear all messages displayed in the DIC and then pull codes as normal.
Alternatively you can go to your favorite parts store and have them use their hand held reader to read the emissions codes. Emissions related codes are what cause the CEL to be illuminated. There are a few emissions related conditions that the C5 built in reader does handle.
NO WAY that code can cause a CEL.
I suggest that you start and run the engine and pull codes with the engine running. To pull codes with the engine running you must use the RESET button to clear all messages displayed in the DIC and then pull codes as normal.
Alternatively you can go to your favorite parts store and have them use their hand held reader to read the emissions codes. Emissions related codes are what cause the CEL to be illuminated. There are a few emissions related conditions that the C5 built in reader does handle.
#3
Intermediate
Thread Starter
Member Since: May 2013
Location: Cincinnati Ohio
Posts: 27
Likes: 0
Received 0 Likes
on
0 Posts
I understand and I am planning on fixing it. However, can the CEL be resetted? If so, how?