Pounder

Sorry I see you have a 2000 !!!!

Pounder

then he should use the doc. from post #29

Dahc

I tried disconnecting and reconnecting the receiver a couple times and got the same result every time. It would work for a minute then stop working. I would have to leave it unplugged for at least 10 minutes. If i unplugged it then plugged it right back in it would not work. I have had the bcm out and everything looked good. The bcm board looked good. I did not see any corrosion or burnt spots.

Pounder

you need to go through the doc. that I gave you to find out what is wrong !!

Dahc

I will go through that document and report back. I really appreciate the great response from this board.

Dahc

Went through diagnostic test and came to the conclusion to replace RFA. Will report back when I get my replacement.

Dahc

Pounder where is the best place to get a service manual? can you get them in digital format?

Dahc

I put the new receiver in and everything is working great. I have tried it a couple times in the past few hours.