[Z06] Headlight buckets
#1
Intermediate
Thread Starter
Member Since: Jan 2013
Location: San Antonio Texas
Posts: 33
Likes: 0
Received 0 Likes
on
0 Posts
Headlight buckets
Well still have headlight issue, I found some plug diagrams for the motors and my motor up wire is constantly hot and motor down barely lights up test light. headlights are down and nothing changes when I turn multifunction switch except lights come on. could the switch be bad or have a bad ground, or the headlight module? any help would be appreciated.
#2
Intermediate
Thread Starter
Member Since: Jan 2013
Location: San Antonio Texas
Posts: 33
Likes: 0
Received 0 Likes
on
0 Posts
Well still have headlight issue, I found some plug diagrams for the motors and my motor up wire is constantly hot and motor down barely lights up test light. headlights are down and nothing changes when I turn multifunction switch except lights come on. could the switch be bad or have a bad ground, or the headlight module? any help would be appreciated.
#3
Intermediate
Thread Starter
Member Since: Jan 2013
Location: San Antonio Texas
Posts: 33
Likes: 0
Received 0 Likes
on
0 Posts
ok im getting power to both up and down circuits from module, o I disconnected plug for motors, and stuck 12 volts to both circuits and the motors didn't do anything. so bad motors AND bad module?
#5
Intermediate
Thread Starter
Member Since: Jan 2013
Location: San Antonio Texas
Posts: 33
Likes: 0
Received 0 Likes
on
0 Posts
Yea I think I have it narrowed to control module. I grounded the motor down wire on plug that gpes into control module and bucket came up. Im assuming the module swaps your ground depending on if you're goin up or down