ECS dyno sheet question...
#1
Drifting
Thread Starter
ECS dyno sheet question...
I copied and pasted this from the ECS website under the SC 1500 supercharger kit C6 Corvette LS2 2005-2007
"Supercharged horsepower and torque data shown is a calculated estimate based on percentage increases from actual rear wheel hp/tq measurements."
then it goes on to show dyno sheets...
So, when I'm looking at a dyno sheet from ECS is it not the actual RWHP but an estimate of the HP at the crank???
"Supercharged horsepower and torque data shown is a calculated estimate based on percentage increases from actual rear wheel hp/tq measurements."
then it goes on to show dyno sheets...
So, when I'm looking at a dyno sheet from ECS is it not the actual RWHP but an estimate of the HP at the crank???
#2
Race Director
Member Since: May 2004
Location: Raleigh, NC
Posts: 16,664
Received 1,194 Likes
on
1,053 Posts
St. Jude Donor '15
I copied and pasted this from the ECS website under the SC 1500 supercharger kit C6 Corvette LS2 2005-2007
"Supercharged horsepower and torque data shown is a calculated estimate based on percentage increases from actual rear wheel hp/tq measurements."
then it goes on to show dyno sheets...
So, when I'm looking at a dyno sheet from ECS is it not the actual RWHP but an estimate of the HP at the crank???
"Supercharged horsepower and torque data shown is a calculated estimate based on percentage increases from actual rear wheel hp/tq measurements."
then it goes on to show dyno sheets...
So, when I'm looking at a dyno sheet from ECS is it not the actual RWHP but an estimate of the HP at the crank???
Last edited by schpenxel; 12-16-2014 at 11:05 PM.
#3
Premium Supporting Vendor
Member Since: Oct 2004
Location: Providing the most proven supercharger kits for your C5/6/7 609-752-0321
Posts: 23,316
Received 1,086 Likes
on
657 Posts
All of our dyno sheets are from a chassis dyno, thanks for your interest.
.
.
__________________
C5/C6 and C7 Supercharging Specialist
ECS Supercharger Kits / Mantic Clutches
www.EastCoastSupercharging.com
Facebook Page
ECS YouTube Channel
C5/C6 and C7 Supercharging Specialist
ECS Supercharger Kits / Mantic Clutches
www.EastCoastSupercharging.com
Facebook Page
ECS YouTube Channel
#4
My 2007 Corvette Z06 LS7 with Camshaft and Ported heads on 3.5lbs of boost made 625hp (wheel HP) on and ECS kit. If I was to increase the diameter opening of the restriction plate a couple mm I could obtain 5lbs of boost and be closer to 700 hp. Great kit.
#5
Drifting
Thread Starter
#6
Race Director
Member Since: May 2004
Location: Raleigh, NC
Posts: 16,664
Received 1,194 Likes
on
1,053 Posts
St. Jude Donor '15
#7
Drifting
Thread Starter
#8
Drifting
Thread Starter
I have no doubt that it is a great kit. I see that many people are happy with it.
#10
Drifting
Thread Starter