Personalized settings.
#1
Drifting
Thread Starter
Member Since: May 2002
Location: Great State Of Arkansas
Posts: 1,520
Received 267 Likes
on
134 Posts
Personalized settings.
I am having trouble reprogramming my car’s seat, mirror and steering wheel memorized settings. When I originally programmed my settings everything seemed to work properly. Then I discovered that the key fobs are numbered 1 & 2. I had originally programmed the number 1 button in the car with the number 2 key fob. Now when I take the number one key fob to the car and try and set it to the number 1 car button, it will not accept the change. Is there a way to erase the entire system and start over? Is the key fob chip that recognizes it as number 1 or 2 in the black plastic part or the metal key part? Thanks!
#2
memory settings
Yes. Hold buttons 1&2 together until you hear a beep. Erases past memory. I had my salesman show me how to program seats and works very well. He followed the book word for word. Also, do the programing while in the cars "Settings" mode. Found on the home page of your computer screen, then "Vehicle" Good Luck
#3
Melting Slicks
Yes. Hold buttons 1&2 together until you hear a beep. Erases past memory. I had my salesman show me how to program seats and works very well. He followed the book word for word. Also, do the programing while in the cars "Settings" mode. Found on the home page of your computer screen, then "Vehicle" Good Luck
#5
E-Ray, 3LZ, ZER, LIFT
Member Since: Sep 2007
Location: NE South Carolina
Posts: 29,503
Received 9,626 Likes
on
6,630 Posts
If you have a std shift, I have not found any either! Where I am told to look, with the emergency key removed, both have a line or you could call it a 1. Others have reported the same. I just put a small key chain on one! The fobs for the automatic have a remote start button.
#7
E-Ray, 3LZ, ZER, LIFT
Member Since: Sep 2007
Location: NE South Carolina
Posts: 29,503
Received 9,626 Likes
on
6,630 Posts
Good pic, that is where mine is and like I see here it is a 1 or a line. Used an eye lop to see clearly! Mine are both the same!! No 2! Again I have a standard shift and our fobs are different in that they have no remote start button.
#8
Intermediate
Member Since: Mar 2014
Location: Woodstock Georgia
Posts: 34
Likes: 0
Received 0 Likes
on
0 Posts
Had my C7 for a little more than a week, and couldn't get the memory seat to recall my position. THIS POST saved the day. My key fobs ARE numbered 1 & 2 and my wife and I had switched, not knowing there was a number system logic. Switched back and life is wonderful.... the seat recalls to #1 on the door panel.
The # of the key is IN the recess of the pull out key, shown in the red circle above. Thanks Glen e.... you saved the day.
The # of the key is IN the recess of the pull out key, shown in the red circle above. Thanks Glen e.... you saved the day.
#10
Moderator
I have the 7 speed manual and my fobs have a 1 and a 2 in them where the photo shows.
#12
Le Mans Master