Lower Control Arm CAM moved...options?
#1
Melting Slicks
Thread Starter
Lower Control Arm CAM moved...options?
So I noticed the forward cam on my driver's rear LCA has moved slightly from when I marked it. Can I just move it back to the mark and call it 'done' or do I need a new alignment?
#2
Tech Contributor
Member Since: Oct 1999
Location: Charlotte, NC (formerly Endicott, NY)
Posts: 40,096
Received 8,929 Likes
on
5,333 Posts
Just move it back and tighten the nut properly so it doesn't slide again.
Bill
Bill
The following users liked this post:
spearfish25 (11-29-2016)
#3
Le Mans Master
Consider buying a camber kit. It comes with blocks and want move.
#5
Race Director
I think there was a German company that may have come out with one, but it was VERY expensive! Take a look on the Katech site to see if it's on there.
The one I know that is being developed is by forum vendor AMT Motorsport. Below is a thread with some info about their C5/6 kit and it looks very nice, and would expect the C7 kit will be very nice as well:
https://www.corvetteforum.com/forums...kit-c5-c6.html
.
The one I know that is being developed is by forum vendor AMT Motorsport. Below is a thread with some info about their C5/6 kit and it looks very nice, and would expect the C7 kit will be very nice as well:
https://www.corvetteforum.com/forums...kit-c5-c6.html
.
The following users liked this post:
Operations (12-06-2016)